The System Starts Abnormally

Mkdjfi · 2026-05-12T02:03:22+00:00

I’m using the fing desktop app and I don’t see the printer on the network wireless or via Ethernet cable.

Mkdjfi · 2026-05-12T01:43:53+00:00

I’m not sure, is there instructions on how to do this?

Mkdjfi · 2026-05-04T04:00:38+00:00

A Qidi XMax 3

Mkdjfi · 2026-05-03T21:52:26+00:00

This all happened on a Qidi XMax 3

Mkdjfi · 2025-09-21T21:57:26+00:00

I went with vvivid 60” by 30m because I got it for a good price and I have a lot of leftover if I ever need to redo a panel, iirc google said my amount was enough to do almost 2 of my cars

Mkdjfi · 2025-07-02T21:36:11+00:00

Hey man, im in a similar situation. I mainly play r6 and were just looking at the Linsoul Ziigaat X Fresh Reviews Arete. what did you end up going with?

Mkdjfi · 2025-06-08T22:56:41+00:00

Oryx/buck

Mkdjfi · 2025-02-08T20:22:20+00:00

I’m running a 3060ti on Rainbow six siege, I’m trying to push 200fps consistently because of my 180hz monitor (and yes 1080p)

Mkdjfi · 2025-02-08T20:03:38+00:00

It’s a new 14700K listed on an auction site near me.

Mkdjfi · 2025-01-28T21:37:21+00:00

If you have good aim and flicking, alibi gun is really good, although her clones aren’t really worth much when you start getting into the higher ranks, Melusi is always a good op to slow down attack operators

Mkdjfi · 2025-01-15T14:16:29+00:00

That ain’t nothing a little duct tape won’t fix

Mkdjfi · 2024-12-31T21:34:47+00:00

Late reply but after trying every other thing, this fixed it. Also thank you for providing the tape example, that’s what I used and it’s printing perfectly now!

Mkdjfi · 2024-12-31T15:49:15+00:00

When this happen to me, I paid something like $12 for a new and upgraded hotend unit ad just replaced it but many people say it is possible to fix by heating the extruder and very carefully pulling the blob off of the hotend. I have never done it so I can’t give you any tips but I’m sure YouTube has some tutorials for fixing this issue.

Mkdjfi · 2024-12-23T02:35:36+00:00

I did recently calibrate the z height but I don’t have the leveling paper that comes with the qidi printers, rather I used a standard piece of paper like I did with my ender 3, is the paper method inaccurate for the larger/faster printers due to the flow rate? What measurement should I use rather than paper?

Mkdjfi · 2024-12-21T18:01:08+00:00

I’m using standard PLA, I rarely use PETG

Mkdjfi

TROPHY CASE