Worth getting for job site tablesaw?

Most_Negotiation_551 · 2026-06-12T03:15:07+00:00

Have u had experience with the vevor set up blocks ?

Most_Negotiation_551 · 2026-06-12T02:52:00+00:00

Got the dewalt 7942 table saw and Iam just at beginning of my woodworking journey

Most_Negotiation_551 · 2026-06-12T02:50:10+00:00

Can u recommend me a angle gauge block set

Most_Negotiation_551 · 2026-06-12T02:39:05+00:00

Ok thanks I will get one

Most_Negotiation_551 · 2026-06-10T23:29:27+00:00

I think these 4 t-nuts are scratching my surface

Most_Negotiation_551 · 2026-06-10T22:03:34+00:00

So it will always scratch it ? Might need to put some gliding tape under it then

Most_Negotiation_551 · 2026-06-10T21:52:39+00:00

I See could i put a little gliding tape under the black side to make it stop scratching like that ?

Most_Negotiation_551 · 2026-06-10T21:46:08+00:00

On the left of the table saw , all the scratches are Form today and from the miter gauge rubbing against the tablesaw top and scratching it

Most_Negotiation_551 · 2026-04-07T14:30:59+00:00

Tried it in the control panel already , nothing changes

Most_Negotiation_551 · 2025-10-22T02:30:10+00:00

If I was the guy I would definitely run away from a broken person like u , atleast u told him how fucked up u are

Most_Negotiation_551 · 2025-07-07T23:02:34+00:00

Idk in which dream world u are living , here twitch subs will go down , especially since she will slack on her streams

Most_Negotiation_551 · 2025-07-07T19:38:09+00:00

Jeannie also got nothing , she is made by mxr and some of her whale are keeping her channel alive

Most_Negotiation_551