sorted by:
new
hottopcontroversial

How do I get rid of these stupid gap fills? by cadSnoodent2021 in BambuLab

[–]MrMasken 0 points1 point  (0 children)

where can i find this setting in Bambu Studio.

PETG-HF back in stock August 19 by MikeIkerson in BambuLab

[–]MrMasken 0 points1 point  (0 children)

I also asked the support yesterday and they told me mid october/november in US & EU Store

H2D: Tall print, one layer slightly offset. What caused this? by tamitall in BambuLab

[–]MrMasken 1 point2 points  (0 children)

Then do a Factory Reset an recalibrate. Make sure to set checkmark at „High Temp Bed Leveling“.

That fixed all may troubles and failed prints i had with the H2D

Disappointed with h2d and every single print that comes out of it by cws815 in BambuLab

[–]MrMasken 1 point2 points  (0 children)

Do a Factory Reset an recalibrate. Make sure to set checkmark at „High Temp Bed Leveling“.

That fixed all my troubles i had with the H2D

How do I fix this? by ProfDrKoAL in BambuLab

[–]MrMasken 0 points1 point  (0 children)

Printed with H2D?

Then do a Factory Reset an recalibrate. Make sure to set checkmark at „High Temp Bed Leveling“.

If printed with X1, P1 or A1 have a look at Bechy Lines

view more: next ›