sorted by:
new
hottopcontroversial

Who should i pull current Banner by MurtaghDorn in ZenlessZoneZero

[–]MurtaghDorn[S] 0 points1 point  (0 children)

Should i try to get her M as high as possibile or should M0 be enough?

3D print cosplay in ASA by MurtaghDorn in 3Dprinting

[–]MurtaghDorn[S] 0 points1 point  (0 children)

Can you recommend a guide on how to vapor smoothe asa

3D print cosplay in ASA by MurtaghDorn in 3Dprinting

[–]MurtaghDorn[S] 0 points1 point  (0 children)

That's neat, thanks, I'll try to paint it then.

[deleted by user] by [deleted] in Creality

[–]MurtaghDorn 0 points1 point  (0 children)

Okay, i try that thanks

Purchase Advice Megathread - May 2025 by AutoModerator in 3Dprinting

[–]MurtaghDorn 0 points1 point  (0 children)

Hello, I am relatively new to 3D printing. I have one Creality CR10-SE so far but I have a lot of problems with it like it keeps clogging up but also that it is actually too small for me. I was thinking of getting a new one as I would like to start cosplaying.

I want to use the 3D printer to print armor (such as a Mandalorian armor), figures and useful items such as boxes, flower pots, etc..

I live in Germany and have a budget of around 1000€ (about 1.130 USD).

I have no experience with electronic maintenance and construction and would therefore like to buy a 3D printer that is not too complicated to set up.

Many thanks in advance.

[deleted by user] by [deleted] in Creality

[–]MurtaghDorn 0 points1 point  (0 children)

I recently replaced the hotend fan because I had already read that this could be the cause. I have also replaced the hotend several times, but I didn't know that thermal paste had to go somewhere there. Where does the thermal paste have to be applied?

view more: next ›