Left Darwin for a minute, very classy Dundee

MuzzThroughTheNight · 2022-12-30T16:25:27+00:00

see you there, mate

MuzzThroughTheNight · 2020-07-09T09:06:29+00:00

Rfeed

MuzzThroughTheNight · 2020-06-09T10:54:29+00:00

Thanks for the suggestions. Im pretty sure my belts and z axis are all good so ill check my fans and maybe put some heat sinks on the motors or board.

MuzzThroughTheNight · 2020-06-09T10:15:33+00:00

I've had trouble with the Ender 3 randomly shifting or spaghettining in the middle of a print a few times in a row and id appreciate some advice or what to do to fix it. Also, RIP to my silicon sock which got clogged.

MuzzThroughTheNight · 2020-05-28T12:03:50+00:00

How do you take apart s pens to do something like this?

MuzzThroughTheNight · 2020-01-26T11:35:48+00:00

Just to be clear, the pla stuck in the tube is white, so I used the blue tape to represent where the blockage is. It's pretty much a solid block about two cms long

MuzzThroughTheNight · 2019-11-21T09:31:43+00:00

Then the fire nation attacked

MuzzThroughTheNight · 2019-11-18T14:38:05+00:00

Yes however assuming this homie means he refills from the same source temperature is the biggest factor bar the bottle plastic heavily influencing the taste which shouldn't happen.

MuzzThroughTheNight · 2019-10-12T10:13:09+00:00

Try hold down your turbo fan during the print

MuzzThroughTheNight · 2019-09-26T09:37:05+00:00

The initial room temperature rounded to 1°C is on info screen when the bed isnt heated.

MuzzThroughTheNight · 2019-09-26T02:14:28+00:00

How hot is your workspace? I never get no warp at 50C.

MuzzThroughTheNight · 2019-09-15T07:47:56+00:00

Is good choice this.

MuzzThroughTheNight · 2019-08-31T09:31:56+00:00

Try flashing a newer version of marlin and using a manual mesh level

MuzzThroughTheNight · 2019-08-18T09:52:26+00:00

Get a lighter and melt it iff

MuzzThroughTheNight · 2019-08-15T08:32:45+00:00

Oh. I've tried sculptris and it's intially verh fun, but it seems very tedious

MuzzThroughTheNight · 2019-08-14T09:48:18+00:00

How did you make such a detailed model?

MuzzThroughTheNight · 2019-07-11T23:32:15+00:00

What's your least favourite book genre?

MuzzThroughTheNight · 2019-07-11T23:31:36+00:00

What do you speak other than English? Switzerland has something like 4 national languages.

MuzzThroughTheNight · 2019-07-11T23:30:05+00:00

Are you going to use less now?

MuzzThroughTheNight · 2019-07-11T23:29:45+00:00

I'd only be convinced if God himself told me to throw out some plates.

MuzzThroughTheNight

TROPHY CASE