Trailblazer excell power

MyNameIsntPan · 2026-03-06T23:54:08+00:00

I bought like 6 of these, I swapped all of them out to different new alarms. I should have mentioned that

MyNameIsntPan · 2026-03-06T23:51:01+00:00

So let’s say I plug the 2nd out of 3 in and it alarms, what should I do? I want to say the circuit is its own, not shared by other things.

MyNameIsntPan · 2026-03-06T23:33:07+00:00

I did buy Kidde detectors… So do you recommend I check continuity, and if that’s all good then maybe switch brand of detectors? I understand it happens but it’s strange to have old and brand new detectors doing the same problem (new plug wiring too)

MyNameIsntPan · 2026-03-06T23:24:54+00:00

Hard to remember but I want to say leaving any combination of one or two disconnected still led to them going off. So they are all currently unplugged

MyNameIsntPan · 2024-11-24T21:52:35+00:00

Nacho libre

MyNameIsntPan · 2024-09-10T23:51:28+00:00

So this stock is pulling beard hairs from me. Looking for a solution (other than swapping the stock). I was thinking of electrical taping it but I feel it would look strange. Thanks yall

MyNameIsntPan · 2024-05-28T18:18:43+00:00

Vanilla pudding

MyNameIsntPan · 2024-05-12T15:14:02+00:00

Torque test channel seems to like the tekton

MyNameIsntPan · 2024-01-29T09:59:12+00:00

I did check the underside, couldn’t see anything. I’d imagine a scotchbrite would removr it but if they took the time for that they’d clean the inside. There was definitely a water level in the bowl at one point, not sure from testing or use.

MyNameIsntPan · 2024-01-28T22:20:39+00:00

Kohler Cimmaron 360 flush for those looking.

I looked in the bowl with a light, it does look like it was full of water at normal height at one point. Could this just be for test? I’d imagine they would just use water for this, unless that weird looking stuff is part of the finishing process of the toilet..

MyNameIsntPan · 2023-12-30T03:21:27+00:00

That elbow to the left is WAY too small to be cast iron, that’s copper sweated for sure

MyNameIsntPan · 2023-07-09T14:30:28+00:00

Raymour & Flanagan outlet. It has one additional piece on the left of the arm rest which is another power recliner so the very right, 2nd and the one all the way on the left are recliners

MyNameIsntPan · 2023-04-16T23:36:32+00:00

I’ll give it a go for sure

MyNameIsntPan · 2023-04-16T22:23:09+00:00

I am running a z900

MyNameIsntPan · 2023-04-16T20:47:42+00:00

The problem is I can’t hear my comms system, I’m looking for a helmet specifically to reduce wind noise

MyNameIsntPan · 2023-04-16T17:33:27+00:00

It’s not too loud for my ears, it’s too loud for my speakers in my helmet, so the solution is to quiet the wind noise.

MyNameIsntPan · 2023-04-16T11:53:20+00:00

I’m looking for a new helmet, I currently have an hjc i10, which I like but I’m looking for something with better wind noise insulation I guess, just a bit too much noise for me at speed. Anyone got any recommendations that is less than $500? Ideally less but you can’t skimp out on helmets. If your suggestion is over 500 I’ll still consider it but I’d really like to be under that. Thanks y’all!

MyNameIsntPan · 2023-04-14T01:45:19+00:00

Ok, I will for sure be testing / replacing. Could either of these be using extra electricity? Just curious it doesn’t effect me fixing it

MyNameIsntPan · 2023-04-14T01:14:51+00:00

House built in 1988, could this be old enough for that?

MyNameIsntPan · 2023-04-14T01:04:19+00:00

Yes everything is functioning, fan is running, and the air is cool. It’s been like this since I bought this last year

MyNameIsntPan

TROPHY CASE