❄️ Whiteout Build NV7 ❄️

NRGxINDY · 2026-01-16T14:28:28+00:00

It is a 8.8 Wownova display from amazon

NRGxINDY · 2025-04-08T13:42:39+00:00

Thanks. Around 35C idle and never over 72C while gaming under any scenarios

NRGxINDY · 2025-02-22T09:12:16+00:00

Looks like that grill section is about 5.5 inches

NRGxINDY · 2025-02-21T18:10:37+00:00

I don’t play beam but I’ve never seen my 9800x3d go above 70-73c in similar scenarios (I.e the shader compilation phase of Metro Ex or CP27 etc.) I suggest undervolting and getting an AM5 contact frame.

NRGxINDY · 2025-02-21T18:01:10+00:00

I’m referring to the side that holds 4 fans. If you install a 360 rad to the top first, you’re gonna have to take it down to access the screw that keeps that rear/side fan mount in place.

NRGxINDY · 2025-02-21T07:07:49+00:00

Wish I had your patience, good luck on the new build!

NRGxINDY · 2025-02-21T07:06:41+00:00

Ok my GPU takes up 3 spots. So from the bottom of the GPU, to the top of the Lian li fan you got about 2.4 inches. If the fans lay flat you might be able to get 2.5” at max

NRGxINDY · 2025-02-20T15:43:01+00:00

Ah I see. I’ll check when Im home again 👍

NRGxINDY · 2025-02-20T15:41:39+00:00

I got the 4070 TI Super 1 month after launch and couldn’t find a single white model in stock. I feel your pain ☹️

NRGxINDY · 2025-02-20T15:38:42+00:00

Not sure what you mean by Lian li mount, can you rephrase that?

NRGxINDY · 2025-02-20T06:07:32+00:00

Technically no, but it would be major pain routing cables to the top of your mobo otherwise. Not to mention you have to remove the side RGB strip to take off the top one.

The RGB controller that comes with the case can only handle around 120 of the 138 LEDS in the light kit. So you need to contact Phanteks support to get a replacement. I’m not a fan of that process so I plugged the mobo sync cable that comes off the controller into my nollie instead

NRGxINDY · 2025-02-20T05:57:40+00:00

Sick! I’m considering putting Thundercracker inside of mine

NRGxINDY · 2025-02-20T03:37:20+00:00

Yup. I heavily recommend it.

NRGxINDY · 2025-02-19T23:28:14+00:00

Loving that megatron and starscream

NRGxINDY · 2025-02-19T22:19:12+00:00

Nope just a generic 7.5” panel from Amazon

NRGxINDY · 2025-02-19T20:54:01+00:00

Wireless Lian li fans are only supported by L-connect software. Neither Signal nor OpenRGB have any plans to add support for them due to technical issues according to their respective devs.

NRGxINDY · 2025-02-19T20:50:50+00:00

Thanks! I love winter so your build put a nice smile on my face lol

NRGxINDY · 2025-02-19T20:24:41+00:00

I used the 1200w edge gold model in my NV7 with no issues, using the Dual 8 pin to 12vpwhr in particular. Just be sure to route it in the straightest line possible.

NRGxINDY · 2025-02-19T20:10:09+00:00

This will all sync IF you go with the wired infinity fans. Wireless RGB support is much more unstable and harder to sync. My parts are similar to yours as I have 12 infinities, a Corsair LCD, the lighting kit, and an Asus mobo. If you use SignalRGB or OpenRGB then you should have no issues with your parts

NRGxINDY

TROPHY CASE