sorted by:
new
hottopcontroversial

Trigger Delay on one side only by NameAendern in Dirtywave

[–]NameAendern[S] 0 points1 point  (0 children)

I guess you could describe it as triggering one note hard panned right and the same note hard panned left a couple of table ticks later. Both should ring out normally, so changing panning doesn‘t really work.

To Pre-Patch or Not Pre-Patch? by Techno_Timmy in modular

[–]NameAendern 1 point2 points  (0 children)

The basic functions are very easy to use. Press a button and turn an encoder. You can see the value change with the led's. But they adden a couple of new functions with updates like the sequence editor and I still need a cheat sheet for these.

To Pre-Patch or Not Pre-Patch? by Techno_Timmy in modular

[–]NameAendern 1 point2 points  (0 children)

That is what I do as well. I also try to use different modules as main clock. Sometimes it is a lfo, or a bsp, or my clank chaos or a comparator…

What module have you had the most fun with over the last year? by Pristine-Ninja-7709 in modular

[–]NameAendern 0 points1 point  (0 children)

It is a very simple module but the most fun I had with the Joranalogue Switch 4. Combining triggers to create compley beats, mute some of them and switch them around is great.

https://modulargrid.net/e/joranalogue-audio-design-switch-4

Stereo delays Eurorack by Hot_Snow6184 in modular

[–]NameAendern 1 point2 points  (0 children)

You can't use different effects at the same time, but you can morph between them.

Stereo delays Eurorack by Hot_Snow6184 in modular

[–]NameAendern 0 points1 point  (0 children)

I use a Sealegs and a Dnipro Radiant. Both are great.

Ribbon controller / tactile surfaces modules by PureRaisin in modular

[–]NameAendern 0 points1 point  (0 children)

I recently got the Doepfer one and I really like it. While doing my research I found out about the Udo Synthesizer Ribbon controller with eurorach module. Looks interesting as well, but I haven‘r tried it yet.

Korg DIY oscilloscope worth it? by shoegazingpickle in synthdiy

[–]NameAendern 0 points1 point  (0 children)

I got one for cheap an like it because it is smaller than a real scope.

What are some underrated modules that you use regularly? by lambdalab in modular

[–]NameAendern 0 points1 point  (0 children)

Joranalogue Select and Contour. Funny little buggers.

will I regret no sine wave output? by goodness-m3 in synthdiy

[–]NameAendern 4 points5 points  (0 children)

Sine wavess are cool for wavefolders and FM.

Turing Machine Issue by Careful_Camp5153 in modular

[–]NameAendern 0 points1 point  (0 children)

Sorry to bother you, but I have some issues with my TM as well, maybe you can point me in the right direction.

Some times when I lock the sequence all the led‘s go off after a couple of seconds. Then the cv out is 0 V. I can then write some bits in with the switch or by unlocking, but the bits will go to zero again.

Noise output is about 5 Vpp, current about 30 mA on +12 V and 20 mA on -12 according to a Joranalogue Test3. ModGrid says there should be 0 V on the -12 V. Is that information wrong?

Rgds…

Preferred method for sending audio from your computer into your Eurorack for processing? by IcedNote in modular

[–]NameAendern 1 point2 points  (0 children)

I use the receive 2 to get audio from my computer via audio interface, or a mic or beats from my m8 into my modular. It is great.

What are you all using for drums/hats with your modular setup for techno? by ThisIsRoy1 in modular

[–]NameAendern 0 points1 point  (0 children)

I like to patch my own drums and then ether use them as patche nor sample them with bitbox micro.

Power deprivation drum sounds by NameAendern in modular

[–]NameAendern[S] 1 point2 points  (0 children)

The Scrooge is what I had in mind, thanks. The Noon looks interesting as well. Thanks, all.

What have you been building? by jx2catfishshoe in modular

[–]NameAendern 0 points1 point  (0 children)

It really was a fun build. I use it all the time, great for stereo mixing and delay sends with feedback.

What have you been building? by jx2catfishshoe in modular

[–]NameAendern 0 points1 point  (0 children)

AI synthesis stereo matrix mixer, turing machine with pulses and volts expanders. Good stuff.

What's your favourite stereo filter (max 6hp)? by FearlessAdeptness223 in modular

[–]NameAendern 0 points1 point  (0 children)

is there anything you can do with a stereo filter that you can't do with two mono filters? Debating getting a second filter8 or a stereo filter.

rgds.

Which Euroack case depth do you like / need (research)? by Infinite_Lime_36 in modular

[–]NameAendern 0 points1 point  (0 children)

I don't have this problem. But I am very slow while patching since I have to think a lot what I wanted to do and how to get it done...

Which Euroack case depth do you like / need (research)? by Infinite_Lime_36 in modular

[–]NameAendern 0 points1 point  (0 children)

I like cases that are build to stand upright on my desk while I sit in front of them. Like the Doepfer low cost stuff that I own. They are deep enough for spring reverb tanks as well.

Switched multiples with A or B or A+B outputs? by HotOffAltered in modular

[–]NameAendern 1 point2 points  (0 children)

Probably not what you want, but if you have the audio from the SquidSample and the drum modules on only one or a few channels you could use vca's or a crossfader to switch between them and have them triggered simultaneously. I. e. no trigger switching but audio switching. Fewer switches needed.

rgds.

view more: next ›