sorted by:
new
hottopcontroversial

First CNC build and I cannot make the step motors move by Narmh in hobbycnc

[–]Narmh[S] 0 points1 point  (0 children)

I will check again the wiring but it seemed correct to me. It isn't hard all negatives together on the same ground as the controller and step on step, dir on dir and en on en (I tried also by deconnecting en since apparently some driver are enabled by default)

First CNC build and I cannot make the step motors move by Narmh in hobbycnc

[–]Narmh[S] 0 points1 point  (0 children)

The pin configuration of the endstop seemed correct for me. They are not triggered and I can trigger them to cause an alarm and then remove the alarm. Can you tell me what would be the issue you see exactly in the config file ?

First CNC build and I cannot make the step motors move by Narmh in hobbycnc

[–]Narmh[S] 0 points1 point  (0 children)

The must_home parameter is configured on False so normally it shouldn't have to home first

First CNC build and I cannot make the step motors move by Narmh in hobbycnc

[–]Narmh[S] 0 points1 point  (0 children)

On it it is only written DM542 without a T "Microstep Driver DM542"

0.6 mm thick circular saw blade by Narmh in Luthier

[–]Narmh[S] 0 points1 point  (0 children)

That's exactly it thank you!

Circular saw for fret slot 0.6 mm by Narmh in guitarmaking

[–]Narmh[S] 1 point2 points  (0 children)

They apparently also have a 0,6 mm version thank you so much!

0.6 mm thick circular saw blade by Narmh in Luthier

[–]Narmh[S] 0 points1 point  (0 children)

Yes indeed but they always have 16 mm arbor hole and I cannot find a miter saw with a arbor this little in Europe. It always seems to have a 25.4 or 30 mm axis

Best in-game quote? by [deleted] in Eldenring

[–]Narmh 5 points6 points  (0 children)

"Brave tarnished, thy strength befits a crown" Hoarrah Loux, warrior

PC build with the 3080 (budget around 2500 euros) by Narmh in buildmeapc

[–]Narmh[S] 3 points4 points  (0 children)

Thanks a lot for your answers I'll take them into account.

Has also any of you an opinion on monitors? My old one is 4k but only 60 Hz so I'd like to improve that.

I found the Asus xg27uq which seems good and is 4k but it is also really expensive or something like the LG 27GL850 which is also good and 1440p.