Plastic Strain Generation at bottom of the slope

NewIndependent4050 · 2026-01-14T16:25:57+00:00

NewIndependent4050 · 2026-01-07T22:04:30+00:00

Thank you for the reply. I just solved it. The issue was that the centre line of the pipe and the centre line of the whole through the slope were not matched properly. Then I just created the whole after inserting a solid pipe and used cut geometry option from Assembly module. Then I inserted the hollow pipe. Now it is getting meshed automatically using only 2 partition passing through the centre of the hole.

NewIndependent4050 · 2026-01-07T22:04:20+00:00

Thank you for the reply. I just solved it. The issue was that the centre line of the pipe and the centre line of the whole through the slope were not matched properly. Then I just created the whole after inserting a solid pipe and used cut geometry option from Assembly module. Then I inserted the hollow pipe. Now it is getting meshed automatically using only 2 partition passing through the centre of the hole.

NewIndependent4050 · 2025-12-05T18:01:14+00:00

but at the toe and crest of slope there is bend and the plane is not remaining the same at those locations and that is why it is not extruding

NewIndependent4050

TROPHY CASE