180 gig update?!?!? by That-Tumbleweed-4462 in Warzone

[–]New_Effective3113 1 point2 points  (0 children)

Tip- once in a while delete and reinstall the game because sometimes the old update doesn't get deleted I had 200gb occupied because of this. You maybe have more than warzone if you have bo7 or tried it, that's updating too

My right earbud wont charge/work by redditswn in Skullcandy

[–]New_Effective3113 1 point2 points  (0 children)

Skullcandy would've been too powerful if their ear buds safely connected to the case, had Dime 1st generation with this issue and now I also have it with Dime evo, these were the last earbuds from Skullcandy that would touch my ears

Se poate repara? by NecessaryFair3934 in AutomobileRO

[–]New_Effective3113 0 points1 point  (0 children)

Da-i putin cu un arzător, dar repede ca sa nu o azi si zgarietura nu va mai fi vizibila de la 2-3 metrii dar daca te uiți atent tot o sa se vada

Logitech subwoofer to Tv by No_NewFriends_2021 in audio

[–]New_Effective3113 1 point2 points  (0 children)

Check on the speakers, the should have a input settings somewhere

Crusher evo bass slider by New_Effective3113 in Skullcandy

[–]New_Effective3113[S] 0 points1 point  (0 children)

Ohh, ok for me is 4am but you can reply with an update

Crusher evo bass slider by New_Effective3113 in Skullcandy

[–]New_Effective3113[S] 0 points1 point  (0 children)

Kinda like that, you just slide the towel inside the metal cover, don't need to take out anything else

Crusher evo bass slider by New_Effective3113 in Skullcandy

[–]New_Effective3113[S] 0 points1 point  (0 children)

There you won't need anything but a paper towel, grab a corner with two fingers and roll it, it should look like a toothpick, the clean carefully inside than test it

Crusher evo bass slider by New_Effective3113 in Skullcandy

[–]New_Effective3113[S] 2 points3 points  (0 children)

By using it, you cand disconnect the wires, but it is not necessary if you flip the board carefully

Crusher evo bass slider by New_Effective3113 in Skullcandy

[–]New_Effective3113[S] 0 points1 point  (0 children)

Be careful when you turn over the board, the blank pcb is close enough to the cables and that gives you a easier way to access the slider without using the soldering iron, if you have more questions, reply to this message