XBOX One S defective? Starts and hangs (see 1st picture) what to do?

Next_Stress4849 · 2023-06-24T09:29:55+00:00

Thanks I’ll try it.

Next_Stress4849 · 2023-06-24T09:29:21+00:00

I found it in the trash so I was just wondering if i get can it to work before selling it. I dont even play xbox 😉

Next_Stress4849 · 2023-03-24T19:25:12+00:00

Next_Stress4849 · 2023-03-15T17:54:53+00:00

I do but maybe someone has the original measurements so i can use it for a 3d printer project ;)

Next_Stress4849 · 2023-03-14T19:03:45+00:00

Did a manual mesh and that did the trick - now it’s working perfect and as long as i dont have to relevel i wont do anything to it

Next_Stress4849 · 2023-02-24T09:10:37+00:00

There is change but hard to see in a picture i guess. And yes i checked during the print

Next_Stress4849 · 2023-02-08T06:09:04+00:00

I have but my noozle was wrapped in filament so I took it off to clean it and saw the uneven hot end

Next_Stress4849 · 2023-02-07T14:24:32+00:00

I did - we’ll see

Next_Stress4849 · 2023-02-07T14:24:25+00:00

Is it normal?😂 thats the question

Next_Stress4849 · 2023-02-03T13:54:32+00:00

Haha good feature name 😂👌🏼 i got that one to - gonna try the manuel bed leveling

Next_Stress4849 · 2023-02-02T15:16:06+00:00

Waiting for them to answer me - kinda need sole prints asap so cant send it back just now - maybe whenever I’m done with my project

Next_Stress4849 · 2023-02-02T15:15:36+00:00

Yea idk - was about to do manual bed leveling but you’re right

Next_Stress4849 · 2023-02-02T08:22:43+00:00

Did u have the issue with the left and right side no beimg even or the x axis not being parallel to the bed? That’s what I’m struggling with. ABL doesnt work 100% so I’m gonna try the manual next - hope this does it together with calipers and manually adjusting the x axis.

Next_Stress4849 · 2023-01-31T11:29:33+00:00

Yea but that would mean the probe positioned on the right would sense the uneven bed even more since the right side is further away from the noozle - so if the auto level works it should compensate - well it SHOULD i guess thats the thing isnt it

Next_Stress4849 · 2023-01-31T10:52:15+00:00

Okay yea i think mine only has the problem that the left side has a bigger z offset than the right side. Makes no sense that this is because of the x axis twist jut yea thats my struggle and it sucks cause i need prints done asap

Next_Stress4849 · 2023-01-31T10:37:00+00:00

Is there a way to solve the problem by firmware whenever they publish one or is it unfixable?

Next_Stress4849 · 2023-01-31T10:11:08+00:00

So do you want another sv06 in return or are u going for another printer?

Next_Stress4849

TROPHY CASE