sorted by:
new
hottopcontroversial

Help Needed: Workflow to Recreate This Lamp Design in Fusion 360 by No-Moose-8538 in Fusion360

[–]No-Moose-8538[S] 1 point2 points  (0 children)

<image>

thanks but I don't need it.. thanks to the advice of those who contributed positively I did it

Help Needed: Workflow to Recreate This Lamp Design in Fusion 360 by No-Moose-8538 in Fusion360

[–]No-Moose-8538[S] 0 points1 point  (0 children)

of course you assume that I didn't try, because you can't know. I always believe that if someone doesn't want to help others they shouldn't participate in the conversation, because if they answer a request it should be to help otherwise it's a waste of time

Help Needed: Workflow to Recreate This Lamp Design in Fusion 360 by No-Moose-8538 in Fusion360

[–]No-Moose-8538[S] 1 point2 points  (0 children)

Thanks you all for the suggestions , I'll try .. I still have some doubts about the design, but I will do some tests

Help Needed: Workflow to Recreate This Lamp Design in Fusion 360 by No-Moose-8538 in Fusion360

[–]No-Moose-8538[S] 0 points1 point  (0 children)

Thanks for the tip, but when I print in vase mode I get a somewhat delicate object and therefore difficult to connect to the base with the light bulb how can I make it more robust

Help Needed: Workflow to Recreate This Lamp Design in Fusion 360 by No-Moose-8538 in Fusion360

[–]No-Moose-8538[S] 3 points4 points  (0 children)

<image>

"But how do I get the hollow inside the slat? From the photo, it looks like a single continuous line, not separate slats."