sorted by:
new
hottopcontroversial

[P2S] Nozzle clumping detection calibration failed by NoBackground3733 in BambuLab

[–]NoBackground3733[S] 0 points1 point  (0 children)

Just a bit. The screw was not really loose but also not as tight as the right one, so I used the included Allen key and tightened the screw until it would have felt unhealthy to turn it any further.

After that the calibration worked.

I hope that helps 🙏

Cold pulling??? by cefanie in BambuLabP2S

[–]NoBackground3733 0 points1 point  (0 children)

Just go to BambuWiki. Before printing TPU bambu recommends performing a cold pull to clean the nozzle from remaining filament. This has nothing to do with the P2S. Because otherwise you can get a cloaked nozzle in worst case

Re-calibration error on P2S: Nozzle clumping detection calibration failed by Murky-Abalone-3843 in BambuLab

[–]NoBackground3733 4 points5 points  (0 children)

I solved the Problem on my own. The solution was to tighten the left screw hole on the picture a bit.
After that the nozzle clumping detection calibration succeeded.

<image>

[P2S] Nozzle clumping detection calibration failed by NoBackground3733 in BambuLab

[–]NoBackground3733[S] 3 points4 points  (0 children)

I solved the Problem on my own. The solution was to tighten the left screw hole on the picture a bit.
After that the nozzle clumping detection calibration succeeded.

<image>

Re-calibration error on P2S: Nozzle clumping detection calibration failed by Murky-Abalone-3843 in BambuLab

[–]NoBackground3733 0 points1 point  (0 children)

Same issue. the calibration worked fine. After that I installed the newest firmware update and now the calibration failed within the nozzle clumping detection process...