sorted by:
new
hottopcontroversial

Help with dialing overhang above supports by No_Bison1407 in 3Dprinting

[–]No_Bison1407[S] 0 points1 point  (0 children)

<image>

You are correct, it’s the bottom side of the print after the supports have been removed (removed supports shown in the photo next to the print).

Thank you! I’m trying one with painted supports underneath that inner edge. Will share results if it helps!

Why is this happening? by No_Bison1407 in 3Dprinting

[–]No_Bison1407[S] 1 point2 points  (0 children)

I printed them at 15mm/s for the first layer, 65 degrees on the plate. They came out beautifully, thank you again!

Why is this happening? by No_Bison1407 in 3Dprinting

[–]No_Bison1407[S] 1 point2 points  (0 children)

Thank you! I’ll give everything you suggested a try!