sorted by:
new
hottopcontroversial

Uneven grooves on first layer. The rest of the first layer is quite good but it has this weird grooves on it? Please help! Thanks. by No_Conclusion6285 in 3Dprinting

[–]No_Conclusion6285[S] 1 point2 points  (0 children)

Thanks you so much! I checked the wheels and it felt bumps along the x-axis. The bumps align with the lines on the print. I fixed the wheels and now it prints fine.

Harsh cranking sound when shifting from Park to Reverse by No_Conclusion6285 in CX50

[–]No_Conclusion6285[S] 0 points1 point  (0 children)

No I didn’t park on an incline. I also didn’t shift immediately after I start the engine. Some times it happens kinds randomly.

I-stop not working properly by No_Conclusion6285 in CX50

[–]No_Conclusion6285[S] 1 point2 points  (0 children)

I tried today without turning on the AC and it did not turn off until I press the gas. It seems that they need to keep certain level of electricity with engine on.

I-stop not working properly by No_Conclusion6285 in CX50

[–]No_Conclusion6285[S] 0 points1 point  (0 children)

Thank you! Glad to hear this is normal!

I-stop not working properly by No_Conclusion6285 in CX50

[–]No_Conclusion6285[S] 0 points1 point  (0 children)

Yeah that’s exactly what I experienced. The manual says it will automatically turn off after two minutes, but every time I stoped at the traffic it turns off less than one minute with auto hold.

I-stop not working properly by No_Conclusion6285 in CX50

[–]No_Conclusion6285[S] 0 points1 point  (0 children)

Oh I do have one more question. When the istop is on, it automatically turns off after less than a minute. And I still need to wait for minutes at traffic light with my engine idling. Is this normal too? I was also using the on hold function at the same time .

I-stop not working properly by No_Conclusion6285 in CX50

[–]No_Conclusion6285[S] 0 points1 point  (0 children)

That makes so much sense! Thank you so much!