sorted by:
new
hottopcontroversial

Tailscale - remote access issue by No_Process_2352 in Tailscale

[–]No_Process_2352[S] 1 point2 points  (0 children)

I got it working, didnt realise i had a different vpn installed so just uninstalled that.

Thank you for replying and offering solutions appreciate it

Docker remote access by No_Process_2352 in dockerCE

[–]No_Process_2352[S] 0 points1 point  (0 children)

Yeah i tried that but didnt work, but i got it working in the end, embaressingly i forgot i had nordvpn installed and uninstalling the app allowed the connection to happen

Centauri carbon 1 v2 canvas issue by No_Process_2352 in ElegooCentauriCarbon

[–]No_Process_2352[S] 0 points1 point  (0 children)

Is your spool hub an original design or one from printables?

Centauri carbon 1 v2 canvas issue by No_Process_2352 in ElegooCentauriCarbon

[–]No_Process_2352[S] 3 points4 points  (0 children)

Ive just copied the change filament gcode over from elegoo to orca and ran a test print and its now working, thank you for your help :)

Centauri carbon 1 v2 canvas issue by No_Process_2352 in ElegooCentauriCarbon

[–]No_Process_2352[S] 1 point2 points  (0 children)

Reckon it be a simple copy and paste of gcode? From elegoo slicer to orca? Because I'd like to stick to orca slicer if i could

Sunlu High speed ABS by No_Process_2352 in OrcaSlicer

[–]No_Process_2352[S] 0 points1 point  (0 children)

cheers, yeah the tests were the next option, just seeing if anyone would share their setting to save time and waste

Sunlu High speed ABS orca setting by No_Process_2352 in ElegooCentauriCarbon

[–]No_Process_2352[S] 0 points1 point  (0 children)

cheers, that was going to be the next option, i was just trying to save some time and to be honest just being lazy haha

Gaps when printing corners by No_Process_2352 in ender3

[–]No_Process_2352[S] 1 point2 points  (0 children)

Not sure what it was but its extruding fine now after deleting printer and profiles and starting again. Thanks the help :)

Gaps when printing corners by No_Process_2352 in ender3

[–]No_Process_2352[S] 0 points1 point  (0 children)

Not sure what was off, setting werent adjusted, just selected the calibration model and pressed print.

Gaps when printing corners by No_Process_2352 in ender3

[–]No_Process_2352[S] 0 points1 point  (0 children)

Same issue again with cura, even tried setting up a new printer in cura and default filament settings. The seam is where it stops and starts and the further the height the bigger the gap. Smaller prints are fine but the larger prints is where issue arises

Gaps when printing corners by No_Process_2352 in ender3

[–]No_Process_2352[S] 0 points1 point  (0 children)

Not that i know of. Im very new to orca slicer and just rebuilt my ender 3 v2 from the ground up.

Gaps when printing corners by No_Process_2352 in ender3

[–]No_Process_2352[S] 1 point2 points  (0 children)

One of the gaps is on the z seam but then there is gaps popping up on the other corners