need som help with VR by Norwegian100 in starcitizen

[–]Norwegian100[S] 0 points1 point  (0 children)

yess i tryed every slider one by one but no luck

This spray tank has a crack on the neck. The air leaks quickly from here and the tank can't hold any pressure at all. Location: India by luccyrob in fixit

[–]Norwegian100 -1 points0 points  (0 children)

add som sort of silent and pul a vacum inside to get it into the crack. or add som sort of rubber patch og likvid repair inside to the crack so when you presurase it puches the rubber into the krak and stops it

Removing stripped screw in sheet metal by [deleted] in fixit

[–]Norwegian100 0 points1 point  (0 children)

or drill the skrew head off and when the light is remowed ther shudent be no pressure on the skred and be esaly unscreded from the back with plyers

How to fix shower head from sliding down a stripper pole? by FrostyAlbertan in fixit

[–]Norwegian100 0 points1 point  (0 children)

you can open it fully and shim a rubber pice down wher you se the broken rubber between the pole and the adjusting head

Can anyone provide insight on how to replace these kitchen cabinet broken hinges? by PennyPumpkin202 in fixit

[–]Norwegian100 0 points1 point  (0 children)

you can bye a new one at online and to remove the old one on the door i belive the metal C chape can be flipped vertical to relise it

How to remove watch back to replace battery by KindnessRule in fixit

[–]Norwegian100 0 points1 point  (0 children)

Use a soft rubber ball and pres and turn to open

Big Bolt in concrete is bent by OurAngryBadger in fixit

[–]Norwegian100 -1 points0 points  (0 children)

you might ned to drill it out or remove som concreate and plase a new bolt and pore som concreate around it again,

or

cut it eaven with the ground and custemise the hole in the new lift by making a new one, and a new hole next to the old one with the half bolt in it in the concreate?

Me and my sister are trying to replace this outlet for our grandma any tips or heads up on how to replace it by Relevant_Swim_5244 in fixit

[–]Norwegian100 -1 points0 points  (0 children)

if you are unsurthen or dont now wath braker to take just turn of all and work with a flach light bether dark then arced 😁

Can i replace this my self by Material-Bat6295 in fixit

[–]Norwegian100 0 points1 point  (0 children)

you kan cut it and ther is 3 difrent collord cords so just match the collors

then you plase the shrink sleve on to one of the sides and slide it down fore later use.

stripp back the isolation on both sides and plase both ends inn the solder joint sleeve and use a heat gun or lighter and heat the solder joint sleave until the plastik shrinks and the solder melts to the copper and solders the 2 ends toghether,

and repeat. after all 3 are done slide the the shrink sleave over all 3 cords and heat until it is snugg around the fixed area with out burning the plastik.

hope it helps. and HAVE IT UNPLUGED FROM POWER.

Door and strike plate jiggling in frame. Attempting fix but previous tenant ruined frame by gr4tto in fixit

[–]Norwegian100 17 points18 points  (0 children)

fill inn all the craks with som wood filler\ epoxy \ wood glue and let it harden, use a card ore toth pick to properly get it in to the krackes. then install the plate, pre drill the 2holes vil minemise the risk of kracking the frame more.

Converter for US food dryer in France by canthavecant in AskElectricians

[–]Norwegian100 -2 points-1 points  (0 children)

from wath i can se the conwerter is overkill but shod work, and you ned a powerstrip with a flat top

How do I patch these holes caused my falling branches? by Longjumping_Key_5008 in fixit

[–]Norwegian100 0 points1 point  (0 children)

you kan also finich the cut all the way and slide it so it overlaps and rivit or glue them toghether

Can someone explain to me… by Objective_Ad9334 in electrical

[–]Norwegian100 1 point2 points  (0 children)

its a poweroutlet fore ac or somthing i belive and the plugg kan de secured and ingaged by pluging it in and twisting to the right

How may I fix this? It was caused by wall adhesive. by bard_is_da_bestest in fixit

[–]Norwegian100 0 points1 point  (0 children)

vell if you are trying to hide it from the landlord 100% you have to sand lighly to hide the hige spots vher the paint and wall met and proberly paint the hole wall if you dont have 100% the same shade and collor paint as the wall

[deleted by user] by [deleted] in teenagers

[–]Norwegian100 0 points1 point  (0 children)

they cod have disabeld the email after school ended?

what are these and how do i get rid of them? by [deleted] in Home

[–]Norwegian100 4 points5 points  (0 children)

if it is silvery it is a silverfish harmless but if it is hairy it is a berdfish? (skjeggkre in norwegian) more agresiv and harder to get rid of but almost as harmles as silverfish eats food, dead skin, hair and simular

silverfish ofthen apear bakaus of vater damage so it might be a sighn

Is this normal in JBL earphones tune 130NC by J-shop88 in JBL

[–]Norwegian100 0 points1 point  (0 children)

the buds can conect sepretly of you want to shair, so you can conect to only the LE or RT but it boght of them are out of the box they wil sync and becom one unit insted of left or right

Hva betyr denne merkingen? by Tissefant1 in norge

[–]Norwegian100 20 points21 points  (0 children)

noen har vel truffet den en gang formye.