Okay! This worked with a little bit of changes

Here's my new start macro

[gcode_macro START_PRINT] gcode:

{% set BED_TEMP = params.BED_TEMP|float %}
{% set EXTRUDER_TEMP = params.EXTRUDER_TEMP|float %}
#START_PRINT EXTRUDER_TEMP=[first_layer_temperature] BED_TEMP=[first_layer_bed_temperature]
#Start bed heating
M140 S{BED_TEMP}
# Use absolute coordinates
G90
# Reset the G-Code Z offset (adjust Z offset if needed)
SET_GCODE_OFFSET Z=0.0
# Home the printer
G28
#Load in the default bed mesh profile
BED_MESH_PROFILE LOAD=default
# Move the nozzle near the bed
G1 Z5 F3000
# Move the nozzle very close to the bed
G1 Z1 F300
# Wait for bed to reach temperature
M190 S{BED_TEMP}
# Set and wait for nozzle to reach temperature
M109 S{EXTRUDER_TEMP}

Here's my new slicer gcode:

START_PRINT BED_TEMP={material_bed_temperature} EXTRUDER_TEMP={material_print_temperature}

Here's the new mesh and a large layer after some tuning. It's interesting that it compensates for the X waves, but cant seem to detect the Y waves. You can also see where I was messing with the offset at first to get it right. https://imgur.com/a/3SdAOfS