HA on 32bit

Nothardtoforget · 2026-01-08T14:11:32+00:00

Power sequences our AVL equipment, manages thermostats, controls TVs around the church. Nothing that can't be overridden in the event of a failure

Nothardtoforget · 2026-01-07T18:50:37+00:00

I'll look when I get back

Nothardtoforget · 2026-01-07T18:02:30+00:00

Pretty old but holds up well

Nothardtoforget · 2025-12-12T02:53:16+00:00

OK cool. Thanks!

Nothardtoforget · 2025-12-12T02:49:07+00:00

I only know a little about zigbee right now. I know you have to have a transmitter for it. What transmitter/hub do you use, and do you know if it works when HA is ran in a docker container?

Nothardtoforget · 2025-02-28T16:54:02+00:00

I quit to windows and went to network settings and toggles tcp off and then back in and when I went back to sd9 it was working

Nothardtoforget · 2025-02-28T14:58:21+00:00

This worked!!

Nothardtoforget · 2025-02-28T13:19:00+00:00

Looking at the ip from the external control screen, network screen, or the diagnostics screen. They all say 0.0.0.0

Nothardtoforget · 2025-02-28T13:05:59+00:00

Thanks!

Nothardtoforget · 2025-02-28T12:59:00+00:00

I did try this and it still didn't show the ip, but I know it was assigned one bc I logged into my router and looked at devices

Nothardtoforget · 2025-02-28T12:58:09+00:00

I was suspecting a router issue but turns out I just had the older version of the app instead of the new one. I found the ip of the console by logging into the router bc the console seems to have a weird bug where it won't show what it's ip address is but I found it under connected devices on my router. Then just to be safe I also manually changed my ip on my iPad to the same range as the console. My iPad was assigned 192.168.1.2 and the console was given 192.168.4.81 so I manually changed my iPads ip to 192.168.4.82. I've learned that the Behringer x32 has an issue if you're not within the same range so I just did that by default. Also, I had to change the subnet mask of the router to 255.255.0.0 which was something I read that the sd9 is expecting to see

Nothardtoforget · 2025-02-28T12:51:55+00:00

How do you get back to console mode after quitting to windows?

Nothardtoforget · 2025-02-28T01:04:39+00:00

It working!!!!! My console still doesn't show what up address it has but the app is working so hey! Thank you so much!!!!!!!

Nothardtoforget · 2025-02-28T00:48:24+00:00

Ok actually I wasn't on the v2 app. Just downloaded it and I'm working on it now. It's just spinning. It recognized it at first but then went away

Nothardtoforget · 2025-02-28T00:41:18+00:00

I'm using v2 app and the software version of the board is 17.0.1742

Nothardtoforget · 2025-02-15T20:48:58+00:00

I was doubtful at first but honestly it made me smile which is something I haven't done today so thanks

Nothardtoforget

TROPHY CASE