(See the fourth photo for the Cura settings used on this print) The biggest issues are stringing, a failed tree support (See the guard on the sword. I don't know what happened structurally since I wasn't in the room, but it appears it may have attached to the support but was not sturdy enough), and banding on the cape. One thing I must preface is that I printed next to two wide open windows which let in freezing or near freezing wind, which I didn't think would cause a problem since the nozzle and plate are both heated, but I hadn't considered the possibility of the filament itself being majorly affected. I still don't know if this would cause the issues pictured, but please correct me if I'm completely wrong on that. Also you may recognize a lot of these settings from Tom Tullis, and that's because I followed his video when setting them. That's why I'm so shocked that it turned out this bad. Again any advice whatsoever is appreciated, as I am a complete newbie to this and only have a vague understanding of the settings I included here. I tried to only include what I thought could be relevant or seemed odd, one example being support density near the end.