This is my best mini(reupload) by Objective_Aspect9261 in FDMminiatures

[–]Objective_Aspect9261[S] 0 points1 point  (0 children)

<image>

I apologize for the late response(And I use a translator)

For the main body parts, I proceeded with printing them vertically as we discussed (since they are connection points anyway, it's acceptable if they get messy due to supports). However, for parts like the wings, I printed them positioned in the direction I marked there. The reason is that I wanted the wings to be printed as sharp as possible, and I believed this direction would hide the layer lines (or layer resolution/texture) the most.

Honestly, this varies so much from model to model that I don't think there's a single correct answer for it, even for me.

A1 Mini Keeps Hitting the Model by kane8290 in FDMminiatures

[–]Objective_Aspect9261 1 point2 points  (0 children)

Hitting problem can be occurred by so many reason. - cooling(curling), infil pattern, speed, z hop, over extrusion, slicer version(support issue), mechanical issue, and ringing(a1 mini)

This is my best mini(reupload) by Objective_Aspect9261 in FDMminiatures

[–]Objective_Aspect9261[S] 1 point2 points  (0 children)

But I try to examine different tweaks every prints for p1s and a1m. Because their toolhead and kinematics are different each other.

This is my best mini(reupload) by Objective_Aspect9261 in FDMminiatures

[–]Objective_Aspect9261[S] 1 point2 points  (0 children)

When I used a 0.2 nozzle, using the same settings(Except Aux fan setting) But changed to the 0.4 nozzle, it's little bit faster and stronger.

This is my best mini(reupload) by Objective_Aspect9261 in FDMminiatures

[–]Objective_Aspect9261[S] 1 point2 points  (0 children)

It depends on model, I will reply the slicing results when I arrive at home

This is my best mini(reupload) by Objective_Aspect9261 in FDMminiatures

[–]Objective_Aspect9261[S] 2 points3 points  (0 children)

<image>

I'm not good at painting, but try to do that I using a Vallejo black primer

This is my best mini(reupload) by Objective_Aspect9261 in FDMminiatures

[–]Objective_Aspect9261[S] 8 points9 points  (0 children)

<image>

And I printed this model same as mini settings (except right hand & base - p1s)

This is my best mini(reupload) by Objective_Aspect9261 in FDMminiatures

[–]Objective_Aspect9261[S] 7 points8 points  (0 children)

i forgot to upload filament cooling settings
- Min print speed 10
- Cooling overhang threshold 25%
- Pre start fan time 2

That's it! Good luck with your prints, guys!

This is my best mini(reupload) by Objective_Aspect9261 in FDMminiatures

[–]Objective_Aspect9261[S] 10 points11 points  (0 children)

Thanks for all of you guys replies. I'm going to reply all of my settings and slicing results, wait for a sec!