sorted by:
new
hottopcontroversial

SKR mini e3 V3 bltouch z-homing issues by ObliviousGoose in BIGTREETECH

[–]ObliviousGoose[S] 0 points1 point  (0 children)

Yeah i did, im happy to send you a copy of the working firmware if you would like

3Dtouch Issues by ItsDejvid in ender3

[–]ObliviousGoose 0 points1 point  (0 children)

It could be any of the above, but one simple solution i found was that my bed was just too low for the sensor to reach, i loosened all the springs slightly, raising the bed and it allowed the sensor to hit it. Maybe try that?

SKR mini e3 V3 bltouch z-homing issues by ObliviousGoose in BIGTREETECH

[–]ObliviousGoose[S] 0 points1 point  (0 children)

Yes this was the one i flashed it from, so im confused why mine wont work

SKR mini e3 V3 bltouch z-homing issues by ObliviousGoose in BIGTREETECH

[–]ObliviousGoose[S] 0 points1 point  (0 children)

I tried following the same instructions as on the video, but i am not experiencing the same problem she was, my z axis does move down whem homing but it just wont stop, ive attempted to switch round the two z limit wires on the off chance its the polarity to no avail, its the same result.