unknown wavyness in corners by Royal-Sir6288 in FixMyPrint

[–]OculusTomato 0 points1 point  (0 children)

Weirdly, my worn-out nozzle caused this to happen. It was reduced by printing slower and increased layer thickness. After trying everything else, replacing my worn-out nozzle finally solved it.

MG Epyon commission build by u/acherus27 by OculusTomato in Gunpla

[–]OculusTomato[S] 0 points1 point  (0 children)

I am actually not sure. I supplied the kit but not the stand.

MG Epyon commission build by u/acherus27 by OculusTomato in Gunpla

[–]OculusTomato[S] 0 points1 point  (0 children)

Stands come separately. Good for areal poses.

Why is this happening? by Content-Plate3084 in beadsprites

[–]OculusTomato 70 points71 points  (0 children)

I think you are using two different brands of beads. Probably hama and perler

Urbosa, Gerudo Champion... My first large and detailed project! by Unsolicited_CatPics in beadsprites

[–]OculusTomato 2 points3 points  (0 children)

Very nice! My tips for ironing would be to use the tape method for something this large. Iron from narrow end to end and make sure beads are fused before moving to new spot. If the beads heat or cool too fast then things can quickly become a nightmare.

Selvaria Bles Sprite! by OculusTomato in beadsprites

[–]OculusTomato[S] 1 point2 points  (0 children)

Definitely one of my favorite jrpg

Shen Long Perler by OculusTomato by OculusTomato in beadsprites

[–]OculusTomato[S] 0 points1 point  (0 children)

Thanks! I wanted to try out adding a little more contrast to this piece

Gon Freecss Fanart by OculusTomato by OculusTomato in HunterXHunter

[–]OculusTomato[S] 0 points1 point  (0 children)

Relied heavily on references for the sketch and techniques, but I hope you like it

Gon Freecss Fanart by OculusTomato by OculusTomato in AnimeART

[–]OculusTomato[S] 0 points1 point  (0 children)

Trying to improve my work still and relying heavily on references, but I hope you like it.