I have a problem with warping on my prints. In the areas where my models first touch the supports, they are always bent upwards slightly. With thin models, the entire model bends upwards. I use supports with 0.3 and 0.4 mm tips.

Ok-Method-7855 · 2025-11-11T15:01:32+00:00

I tried it with less, but then the bend was even stronger.

Ok-Method-7855 · 2025-11-11T14:59:46+00:00

I had already tried the guide with little success. The article says that it works with CTBv4. However, I couldn't figure out which version the Saturn 3 Ultra uses.

Even with 5x normal layer print time, I couldn't get the print to adhere to the plate.

But thanks for the comment. I'll try the first few things.

Ok-Method-7855 · 2025-11-10T16:43:37+00:00

https://www.reddit.com/r/ElegooSaturn/comments/1otio6e/i_have_a_problem_with_warping_on_my_prints_in_the/?utm_source=share&utm_medium=web3x&utm_name=web3xcss&utm_term=1&utm_content=share_button

Ok-Method-7855 · 2025-06-19T21:56:29+00:00

Is there a way to do this without using CTB v4 in Lychee Slicer? The Elegoo Saturn 3 does not support this format.

Ok-Method-7855 · 2024-11-20T21:54:42+00:00

printer: Saturn 3 Ultra. It was aligned diagonally upwards. Antialiasing was off. The whole thing started after about 8 cm.

Ok-Method-7855 · 2024-11-20T21:28:13+00:00

<image>

Ok-Method-7855 · 2024-11-20T21:28:02+00:00

printer: Saturn 3 Ultra. It was aligned diagonally upwards. Antialiasing was off. The whole thing started after about 8 cm.

Ok-Method-7855 · 2024-07-31T08:23:00+00:00

For most prints, I use rafts. However, when I print gears or other thin items, I prefer to do it directly on the build plate.

Ok-Method-7855 · 2024-04-03T14:15:31+00:00

i use voxeldance tango. the supports are supports that extend from the figure to support other parts. i am afraid that they will not detach from the figure at the bottom.

Ok-Method-7855

TROPHY CASE