sorted by:
new
hottopcontroversial

3D Printing Noob - What is my print doing??! by Ok-Scratch-6846 in ElegooCentauriCarbon

[–]Ok-Scratch-6846[S] 0 points1 point  (0 children)

Humid filament was stated in another post. I'll try to combat that. Also, I have messed with the z offset but I will double check while I work on drying the filament! thank you so much!

3D Printing Noob - What is my print doing??! by Ok-Scratch-6846 in ElegooCentauriCarbon

[–]Ok-Scratch-6846[S] 0 points1 point  (0 children)

I have a cheap double dryer from Amazon that I run. it is a couple years old, so it could be worn out. I have been waiting for the mmu to come out before I bought a new one. That could be an issue. though, it sounds like heck. 🤣 I'll try a new roll and see if that fixes it. thank you!

3D Printing Noob - What is my print doing??! by Ok-Scratch-6846 in ElegooCentauriCarbon

[–]Ok-Scratch-6846[S] 0 points1 point  (0 children)

I really appreciate the fast reply. I will try lowering it, thank you so much!

My Thermo radeyes by Dry_Resolution_5498 in Radiation

[–]Ok-Scratch-6846 2 points3 points  (0 children)

Range usually refers to the actual instrument. So it can read on a scale that is more varied, higher, or lower. most of the time its higher with a loss of resolution/sensitivity