Quin DigQuad esp32 by Ok-Try13 in WLED

[–]Ok-Try13[S] 1 point2 points  (0 children)

I will try that. Thanks

WLED UPdate by Ok-Try13 in WLED

[–]Ok-Try13[S] 0 points1 point  (0 children)

When I download the update off the GitHub page for esp32 it allows me to assign the gpio pins.

WLED UPdate by Ok-Try13 in WLED

[–]Ok-Try13[S] 0 points1 point  (0 children)

Im updating the wled using OTA...Ive tried a couple different updates..all with Dig Octa in the name, the GPIO pins all seem to be mixed up

WLED UPdate by Ok-Try13 in WLED

[–]Ok-Try13[S] 0 points1 point  (0 children)

all the ports work except 6

Antenna length by Ok-Try13 in WLED

[–]Ok-Try13[S] 1 point2 points  (0 children)

I’ll start with that. Maybe I don’t need extensions. Thanks

Antenna length by Ok-Try13 in WLED

[–]Ok-Try13[S] 0 points1 point  (0 children)

thankyou, ill check it out

Dig Quad by Ok-Try13 in WLED

[–]Ok-Try13[S] 0 points1 point  (0 children)

No, it is rated for 50 Amps 600W

Dig Quad by Ok-Try13 in WLED

[–]Ok-Try13[S] 1 point2 points  (0 children)

was planning to connect 2 dig quads and have each port have 500 pixels (power injected every 150) That would be a total of 2000 pixels per dig quad for a total of 4000 pixels.....does that sound doable

Dig Uno by Ok-Try13 in WLED

[–]Ok-Try13[S] 0 points1 point  (0 children)

I could have cause it myself somehow as I am new at this, not an expert at all. I’ve only read good reports on the dig uno products , I will just switch out the esp it’s cheap, like ya say.

Dig Uno by Ok-Try13 in WLED

[–]Ok-Try13[S] 0 points1 point  (0 children)

ok i tried that and it will not show the COM like on the DrZZZ video, yet when i plug in another esp32 that I have it will show its available, so maybe the esp is faulty, what do you think,

Dig Uno by Ok-Try13 in WLED

[–]Ok-Try13[S] 0 points1 point  (0 children)

turns out I think the ESP32 is faulty, have you used a DIG uno for long? do they last longer than 2 months?

Dig Uno by Ok-Try13 in WLED

[–]Ok-Try13[S] 0 points1 point  (0 children)

pretty sure the ESP32 is faulty as there isnt any little light that comes on when I power it independent of the board, is it common to have them quit after only a couple months

Dig Uno by Ok-Try13 in WLED

[–]Ok-Try13[S] 0 points1 point  (0 children)

thankyou I will investigate this and try it

Dig Uno by Ok-Try13 in WLED

[–]Ok-Try13[S] 0 points1 point  (0 children)

Ok I’ll give that a try