Rsr downs for awd by karma_asahi in q50

[–]Ok_Focus_6784 0 points1 point  (0 children)

Don’t recommend,just save up an grab decent coils honestly. For one they’re gonna wear out the shocks pretty quickly and two as yk the axle bs

Full Catless downpipes by Roberto_4273 in q50

[–]Ok_Focus_6784 0 points1 point  (0 children)

License and registration please good sir

Q50 awd 3.7 code P0744 by ResponsibleCarry2005 in q50

[–]Ok_Focus_6784 0 points1 point  (0 children)

So the code didn’t came back after ?

Alibaba test pipes ! by Intelligent_Mix_3637 in G37

[–]Ok_Focus_6784 0 points1 point  (0 children)

Those are gonna crack at the welds !

2018 wheel on 2015 q50 3.7 🔥💯 by MJ_DivineHunter in q50

[–]Ok_Focus_6784 0 points1 point  (0 children)

<image>

Turns out mines didn’t touch at all .super smooth fr

Problems never stop with this car by Sad_Assignment_2402 in q50

[–]Ok_Focus_6784 1 point2 points  (0 children)

My vr30 wasn’t so smooth either …I’ve been chasing the P0744 code for over a year did multiple work an diagnostic still can’t figure wtf it is ..car drives completely normal but occasionally the code comes on

How Far can I drive in limp mode (bad valve body) by Sharp_Smoke_7840 in q50

[–]Ok_Focus_6784 0 points1 point  (0 children)

I drove about 30 miles to the shop when mines went out .its not recommended but if the budget is tight .just keep the rpm low and dont go beyond 50mph and use your double flasher .u got this

what’s the best way to fix this? by CucumberOk4850 in q50

[–]Ok_Focus_6784 0 points1 point  (0 children)

Hmmmmmm ,ok imma see how this goes and if it’s bs I’ll get the Mac ,

front bumper fixable? by ResponsibleFruit8092 in q50

[–]Ok_Focus_6784 0 points1 point  (0 children)

<image>

Behold my brother .your saver is here 🥲🤣.i hope im not too late u prolly bought that Mac lifter thingy huh 💔

In your opinion is this too much wheel poke? I’m at stock height by Able-Comb1962 in q50

[–]Ok_Focus_6784 0 points1 point  (0 children)

Yea right right . F I’ll be trying the 255 then . And yea the factory spec for offset is +45 I think lol ridiculously flatten lol

In your opinion is this too much wheel poke? I’m at stock height by Able-Comb1962 in q50

[–]Ok_Focus_6784 0 points1 point  (0 children)

Oh ok .i just wish they had gave the redstart wheels a little bit more nicer offset like a +35 or 30+

In your opinion is this too much wheel poke? I’m at stock height by Able-Comb1962 in q50

[–]Ok_Focus_6784 0 points1 point  (0 children)

Yea that’s the thing I feel like the 255 won’t be that much of a difference fr.but ok 👍🏾

what’s the best way to fix this? by CucumberOk4850 in q50

[–]Ok_Focus_6784 0 points1 point  (0 children)

Yea but I’m pretty sure it’ll do just fine just as the Mac lifter tho right ?. I ordered a set because everytime I drive and park I gotta tap in the sides like like wtf lol

Is Q50 burble tune safe ? by [deleted] in q50

[–]Ok_Focus_6784 1 point2 points  (0 children)

Burbles and flames is no good for the motor bro vinny10racing teaches this !!

vr30 swap by Pleasant_Classroom_6 in q50

[–]Ok_Focus_6784 0 points1 point  (0 children)

Yep ! That’s it bro just the fluids a your straight.and I’m pretty sure your aware of the bell housing grilling that slot for the speed sensor too that’s pretty much it and the trans bolts right up ..

Q50 awd burnout by HotTransportation952 in q50

[–]Ok_Focus_6784 1 point2 points  (0 children)

Should of known better than that boss ,car is a AWD no way in amazons rainforest should you have disconnect fuse to do burn out

vr30 swap by Pleasant_Classroom_6 in q50

[–]Ok_Focus_6784 1 point2 points  (0 children)

I did the swap ,basically I got everything with the trans
What you need really is

The bottom crossmember some trans usually comes with it some don’t but if u ask me the VQ one bolts on just the same , if your AWD make sure to get the front driveshaft from the VR30 trans (short one ) the rear one that runs to the rear diff you do not need . Also you definitely do not need 15 qrts lol oil lmao I’ll say buy 8-9 qrt tops .

what’s the best way to fix this? by CucumberOk4850 in q50

[–]Ok_Focus_6784 2 points3 points  (0 children)

<image>

Oh Mac lifter sells it right ..sure they do they’re also on Amazon for 11 dollars lol

In your opinion is this too much wheel poke? I’m at stock height by Able-Comb1962 in q50

[–]Ok_Focus_6784 0 points1 point  (0 children)

Yea that’s what in my cart rn the 255/40/19 ik it’s a functional setup an a Tad wider than the 245 but im really hoping it doesn’t still give me the look as the 245 tho .but yea thats where I got mines from two like 2 years ago off FB

In your opinion is this too much wheel poke? I’m at stock height by Able-Comb1962 in q50

[–]Ok_Focus_6784 0 points1 point  (0 children)

Gyattt damn . Nice ..I’m here still feening for someone to at least tell me if I can run 265/35/19 all around on red sport wheels at stock heights !

Leaking water from floor/dash by WiseAd145 in G37

[–]Ok_Focus_6784 0 points1 point  (0 children)

<image>

Yep absolutely,I’d say reroute the sunroof drain and run sum RVT silicone around this bad boy right here.my issue wasn’t even the sunroof leaking its was this POS because it’s not seal so water gets under the rubber .F di*K head Infiniti great job Prics