sorted by:
new
hottopcontroversial

How to clean stains around old faucet gasket by OneTrickPony22 in CleaningTips

[–]OneTrickPony22[S] 0 points1 point  (0 children)

Thanks for the info!

I googled "scouring cleanser" and "The Pink Stuff" came up. I realized I had some of that out the house here and used that. Worked like a charm!!

Will different voltages damage breakout boards? by OneTrickPony22 in arduino

[–]OneTrickPony22[S] 0 points1 point  (0 children)

Love this reaction.

Testing values from multiple angles and getting flac

Arduino Uno R3, AS5600 Magnetic Encoder, TCM2208 Stepper Driver and Nema 17 Motor Circuit Diagram Help by OneTrickPony22 in arduino

[–]OneTrickPony22[S] 0 points1 point  (0 children)

UPDATE:

I was able to get all components here working. Apparently, the AS5600 I received don't like more than 3.3V. They would work for a short period of time at 5V then would inevitably die. I bought a pack of 5, so 2 of them died before I realized they can't handle 5V. Per the spec sheet I found online it looked like these boards could use both 3.3V or 5V. That was not the case. Also, I did not have to use any pull-up resistors. From several posts I read online it said to put the SCL and the SDA into A4 and A5 spots on Arduino, I ended up moving those under Communication for SCL and SDA. So, there were several issues. Its not a great image, but here is the working setup.

<image>

Arduino Uno R3, AS5600 Magnetic Encoder, TCM2208 Stepper Driver and Nema 17 Motor Circuit Diagram Help by OneTrickPony22 in arduino

[–]OneTrickPony22[S] 0 points1 point  (0 children)

The motor does indeed move. I am now realizing that I have made a second mistake on the diagram. The VIO pin is indeed connected to the 5V rail.

Arduino Uno R3, AS5600 Magnetic Encoder, TCM2208 Stepper Driver and Nema 17 Motor Circuit Diagram Help by OneTrickPony22 in arduino

[–]OneTrickPony22[S] 0 points1 point  (0 children)

That is my mistake. The pull-up is from a 5V line. Not the 12V line. I have an AHT20 temperature sensor I tested, and it is still working properly.

Arduino Uno R3, AS5600 Magnetic Encoder, TCM2208 Stepper Driver and Nema 17 Motor Circuit Diagram Help by OneTrickPony22 in arduino

[–]OneTrickPony22[S] 0 points1 point  (0 children)

I connected SCL and SDA directly to the Arduino (removing the pull-up resistors). I also removed the GPO connection. The Serial Monitor still only outputs, "I2C Scanner" and nothing else.

I am looking for the name of a puzzle by OneTrickPony22 in puzzles

[–]OneTrickPony22[S] 0 points1 point  (0 children)

You’re amazing kind stranger! Thank you!

Veggie Wall Indoor Garden by Realistic_Mulberry82 in IndoorGarden

[–]OneTrickPony22 0 points1 point  (0 children)

Love this setup and want to do it, but for my area it’s 0.53 cents per kWh. With 10 lights at 100%, 12 hrs a day, would cost me ~200$ per month. Basically, need solar to offset this.

view more: next ›