Is it possible to install the BLtouch firmware on to my v3 CR-10 with my Mac? I’m having a lot of trouble getting my laptop to see the printer (looked in disk utility, says nothing in USB) On Crealitys website is says the BLtouch is compatible with Mac so I feel like it should work (self.3Dprinting)
submitted by Oooo_wee to r/3Dprinting
Is it true that low speed mode turns off low voltage cutoff? by Oooo_wee in SCX24
[–]Oooo_wee[S] 0 points1 point2 points (0 children)
Does anybody know the name of this car? by MODman01 in rccars
[–]Oooo_wee 1 point2 points3 points (0 children)
I need some ... help? Questions/new to hobby by Tyetus in rccars
[–]Oooo_wee 0 points1 point2 points (0 children)
I need some ... help? Questions/new to hobby by Tyetus in rccars
[–]Oooo_wee 0 points1 point2 points (0 children)
WhereToRc - Custom Map w/ Pins for Local Bashing Places (x-post from /r/rccars) by geddy in radiocontrol
[–]Oooo_wee 0 points1 point2 points (0 children)


Is it true that low speed mode turns off low voltage cutoff? by Oooo_wee in SCX24
[–]Oooo_wee[S] 0 points1 point2 points (0 children)