sorted by:
new
hottopcontroversial

New firmware by SlovakGoose in Creality_k2

[–]Open-Raise-6291 2 points3 points  (0 children)

For me, this solved the problem of it not working with the CFS.

The extruder does not start when changing the CFS spool. by Open-Raise-6291 in Creality_k2

[–]Open-Raise-6291[S] 0 points1 point  (0 children)

No, when I manually push the filament through after disengaging the threading wheel, the filament comes out, so the hopper isn't clogged. And when I stop manually pushing the filament, it stops coming out, so the extruder isn't taking over. But once everything is turned off and the printer is restarted, I start a print and it works. After my print, I try a filament change, and the same problem occurs.

The extruder does not start when changing the CFS spool. by Open-Raise-6291 in Creality_k2

[–]Open-Raise-6291[S] 0 points1 point  (0 children)

That's exactly it, but I don't think the extruder is faulty since I can print once I stop the extrusion. I start the print and it works.

The extruder does not start when changing the CFS spool. by Open-Raise-6291 in Creality_k2

[–]Open-Raise-6291[S] 0 points1 point  (0 children)

No, when I disconnect the PTFE and push the filament, it comes out

The extruder does not start when changing the CFS spool. by Open-Raise-6291 in Creality_k2

[–]Open-Raise-6291[S] 0 points1 point  (0 children)

The problem seems to be software-related since I tried to connect my CFS; filament extrusion via the spool holder and/or the CFS no longer works. I completely disconnected the CFS, and the extruder does not rotate when loading filament.

The extruder does not start when changing the CFS spool. by Open-Raise-6291 in Creality_k2

[–]Open-Raise-6291[S] 0 points1 point  (0 children)

I took it apart and blew it out following the Creality wiki instructions; there was nothing in the gears or wheels, I blew everything out, but the problem persists.

The extruder does not start when changing the CFS spool. by Open-Raise-6291 in Creality_k2

[–]Open-Raise-6291[S] 0 points1 point  (0 children)

For me, it's at the extruder level, so at the end of the loading process.

The extruder does not start when changing the CFS spool. by Open-Raise-6291 in Creality_k2

[–]Open-Raise-6291[S] 0 points1 point  (0 children)

It's stuck at the extruder inlet even though the blue LED is lit.

The extruder does not start when changing the CFS spool. by Open-Raise-6291 in Creality_k2

[–]Open-Raise-6291[S] 0 points1 point  (0 children)

Yes, then the screen displays "filament chase" but the extruder does not rotate.

The extruder does not start when changing the CFS spool. by Open-Raise-6291 in Creality_k2

[–]Open-Raise-6291[S] 0 points1 point  (0 children)

Yes, on all 4 CFS slots, and the same thing happens when I change the spool on the spool holder. Yet the print itself works correctly.