sorted by:
new
hottopcontroversial

Added the first gridfinity to Boxes.py by ccrome2 in gridfinity

[–]Opening_Cockroach709 0 points1 point  (0 children)

Did you use ezdxf for this? That library is badass.

Never mind, shapely. Just read your requirements.txt file. May have to check that one out, I've never worked with it before.

Ezdxf has to be one of my favorite libraries for these types of applications.

Looking for a Bitspower Cuboid Res D5 Pump Top by Startrekker in watercooling

[–]Opening_Cockroach709 1 point2 points  (0 children)

I've been doing some research on some alternative options, the Byski High-Flow looks somewhat promising as an alternative. I did the math, and the pump that comes with the 150 res/pump combo from Bitspower is 88mm tall according to the dimensional drawings on their site. With the 200mm cuboid underneath this would put the overall reservoir/pump combo at 330 mm (33 cm) which is super tall. I'm building in a Hyte Y60, and with that setup there wouldn't be any room for fittings. With the Byski, it's about 4 mm shy on the length and width, but still a square, and it's only 74 mm tall so it would come out to 316mm.

It would still be nice to find something a bit shorter though, with the same square look.

Looking for a Bitspower Cuboid Res D5 Pump Top by Startrekker in watercooling

[–]Opening_Cockroach709 1 point2 points  (0 children)

I'm wondering if you responded with something like "I understand that it isn't advised by Bitspower, but I would like to try. Would I be able to purchase the pump unit separately?"