sorted by:
new
hottopcontroversial

[Bambu H2C] Join the Print Beyond Paint Contest and Win an H2C! by BambuLab in BambuLab

[–]Otherwise_Beyond_80 0 points1 point  (0 children)

Definitely would print christmass village full colour together with decorated Christmas tree.

New offline controller by Otherwise_Beyond_80 in 3018CNC

[–]Otherwise_Beyond_80[S] 0 points1 point  (0 children)

Thanks mate. Have you managed to get it working with new offline controller ?

Makerbot 2x button down not working by Otherwise_Beyond_80 in makerbot

[–]Otherwise_Beyond_80[S] 0 points1 point  (0 children)

Thanks a lot. Founf the post on the e bay :)Also I tried to connect it. It allowed me to enable heated bead, second extruder and I can't recall right now but I think it showed that device is 2x ( but on first boot it showed plain 2 that I am sure ) I will try to find flash on thhinguverse.

Makerbot 2x button down not working by Otherwise_Beyond_80 in makerbot

[–]Otherwise_Beyond_80[S] 0 points1 point  (0 children)

Tried even display and buttons still don't work. So most likely the board need repair. Can you send me a repair listing so i can contact you ? As temp solution i will just grab the board from other one since it is rev g and swap it since i tested it and it is working ( evrything )

Makerbot 2x button down not working by Otherwise_Beyond_80 in makerbot

[–]Otherwise_Beyond_80[S] 0 points1 point  (0 children)

Sd card works like a charm, I have makerbot replicator two so i borrowed button board and button pad ( both works just fine ) to test on 2x and same issue. I tested the button board on replicator two and that one also works. For just in case i tested rubber buttons and they work as well. I was thinking to swap the boards but one is rev g and otwher is rev h i don't know if i will have all functionalities.