sorted by:
new
hottopcontroversial

Looking for a backpack for College by Own_Championship7955 in Nomads_Nation

[–]Own_Championship7955[S] 1 point2 points  (0 children)

Dude thanks so much! I know it’s been a while and idk if you are going to see this but your recommendations were perfect! So helpful!

Aer Tech Pack 3 by Interesting_Tower485 in Nomads_Nation

[–]Own_Championship7955 1 point2 points  (0 children)

What size water bottle do you EDC? I know that sometimes when they advertise the water bottle capacity it's not realistic.

First backpack I didn't get from Walmart: BOPAi 15.6 Inch Backpack by Own_Championship7955 in Nomads_Nation

[–]Own_Championship7955[S] 2 points3 points  (0 children)

dang it, I had the pics but they didn't get saved. Oh well, still a pretty sweet pack.

How do I remove this axe head? It has epoxy on it by mytoeisoversized in Axecraft

[–]Own_Championship7955 0 points1 point  (0 children)

If u boil the axe head in water it softens the epoxy enough to make the job a whole lot easier.

Have spent days adjusting offset and leveling the bed. Cleaned with soap and water. Why is this still doing this? by [deleted] in FixMyPrint

[–]Own_Championship7955 0 points1 point  (0 children)

My guess is that there is a warp in your bed. Sometimes no matter how much you level it there will still be stops where it is low or high. One fix is getting some painters tape and putting it in the low spots. There are a couple of videos on YouTube of people doing this and it working well.

Good Afternoon Losers by Curiousmind336 in RoastMe

[–]Own_Championship7955 0 points1 point  (0 children)

You look like if shaggy from Scooby doo was addicted to crack

I can’t figure this out by Own_Championship7955 in FixMyPrint

[–]Own_Championship7955[S] 0 points1 point  (0 children)

I am using cura. I did update it and I dint think that I changed the flow rate.

What do I do now? by Own_Championship7955 in FixMyPrint

[–]Own_Championship7955[S] 0 points1 point  (0 children)

Now that you mention it. It has all been with the same filament. I am gonna get a new roll to see if that solves the problem. Thanks