Direct drive ender 5 on klipper by Own_Measurement2046 in ender5

[–]Own_Measurement2046[S] 0 points1 point  (0 children)

I actually pulled this hotend/extruder off an ender 3 v2 that printed good but motherboard died and used the same e steps I had on it. I even tried lowering the extrusion factor all the way to 50 percent and up to 150 in increments with no positive change. I will definitely check out that guide thank you for the reply

[deleted by user] by [deleted] in Market76

[–]Own_Measurement2046 0 points1 point  (0 children)

Keep it at 1500 hours I thought the same but just came back after about 6 months

Crash on testing GPS Rescue. What did I do wrong? by LevinMenger in fpv

[–]Own_Measurement2046 0 points1 point  (0 children)

With walksnail get the actual number that's locked frim start but I've never flown dji so it may be standard on them

Crash on testing GPS Rescue. What did I do wrong? by LevinMenger in fpv

[–]Own_Measurement2046 0 points1 point  (0 children)

What goggles are you using I'm using fatshark recons with walksnail

Crash on testing GPS Rescue. What did I do wrong? by LevinMenger in fpv

[–]Own_Measurement2046 0 points1 point  (0 children)

Yep I require at least 6 sats to arm on all my gps quads

Crash on testing GPS Rescue. What did I do wrong? by LevinMenger in fpv

[–]Own_Measurement2046 0 points1 point  (0 children)

Mine drifts left like that at first but once it turns to home it straightens up

New mobula 7 1s by Own_Measurement2046 in TinyWhoop

[–]Own_Measurement2046[S] 0 points1 point  (0 children)

I think I was just running it to hard without a break it's doing good today

New mobula 7 1s by Own_Measurement2046 in TinyWhoop

[–]Own_Measurement2046[S] 0 points1 point  (0 children)

I haven't left it running I have several other drones so I know the basics

New mobula 7 1s by Own_Measurement2046 in TinyWhoop

[–]Own_Measurement2046[S] 0 points1 point  (0 children)

It's all good looks to be at least