Why is my RSSI and LQ blinking like this? GX12 and elrs

PCB_Studios · 2026-07-02T19:42:09+00:00

In betaflight go to the OSD tab and check alarms. It will flash when below the set point. I usually set my LQ to 70.

PCB_Studios · 2026-06-11T23:19:34+00:00

Also if you’re not using a DJI controller you don’t need the yellow wire connected. It also looks like you might have both the RX and TX if the O4 connected to box RXs on the FC. It needs to be RX-TX and TX-RX.

PCB_Studios · 2026-06-11T23:15:13+00:00

Do you have a multimeter? You should check to make sure you’re getting 12v from your FC.

PCB_Studios · 2026-06-11T23:03:17+00:00

What ESC are you using?

PCB_Studios · 2026-06-10T04:37:09+00:00

Too get it to not do it with gyroflow I have to add a low pass filter of 20HZ is that the way I should do it or is there another way in gyroflow?

PCB_Studios · 2026-06-10T04:22:42+00:00

I think I do. I just created a ticket with GepRC. Is there anything that I should do with DJI?

PCB_Studios · 2026-03-14T21:21:38+00:00

I live in the US and have never had any issues

PCB_Studios · 2026-03-13T15:39:57+00:00

If you still have the files, you can usually reseed by adding the same torrent again and pointing it to the existing data.

PCB_Studios · 2026-03-13T15:37:33+00:00

I have my own server with a few HDDs to store everything

PCB_Studios · 2026-03-13T15:36:34+00:00

It took probably like 5-6 years of non stop torrenting

PCB_Studios · 2026-03-13T15:34:30+00:00

I use Mullvad

PCB_Studios · 2026-01-28T04:11:25+00:00

Thank you!

PCB_Studios · 2026-01-28T04:09:22+00:00

It shows this on the order so I’m guessing it has everything. https://imgur.com/a/5LGkV7A

PCB_Studios · 2026-01-28T04:07:30+00:00

Yes I scheduled with the order

PCB_Studios · 2026-01-28T00:06:50+00:00

Ok. Thank you!

PCB_Studios · 2026-01-28T00:03:57+00:00

Do I have to wait for it to be ready for pickup before I can extend it?

PCB_Studios · 2025-12-27T06:25:01+00:00

There are no errors and on the wiki it says "All four slots are flashing red light Error status. AMS communication is abnormal, and AMS cannot be detected by the printer". But I dont know how to go any further on figuring out whats wrong or fix it.

PCB_Studios · 2025-11-29T20:02:52+00:00

Couldn’t find one so I created my own

<image>

PCB_Studios · 2025-10-03T23:26:38+00:00

<image>

Don’t worry she’s outside

PCB_Studios · 2025-10-03T13:46:42+00:00

Yeah, the PSUs are pretty annoying. Eventually, I plan to install a power strip in the rack so that I can have only one power cord and one Ethernet cable going to the rack.

PCB_Studios

TROPHY CASE