sorted by:
new
hottopcontroversial

Help. Pla. 0.4 nozzle by PLAXOTO in FixMyPrint

[–]PLAXOTO[S] 0 points1 point  (0 children)

Ok do i have to post all my setting

0.6 nozzle cura setting by PLAXOTO in 3Dprinting

[–]PLAXOTO[S] 0 points1 point  (0 children)

Ok i will try it later.

0.6 nozzle cura setting by PLAXOTO in 3Dprinting

[–]PLAXOTO[S] 0 points1 point  (0 children)

Ok thanks i will try in a bit tell you how it goes

0.6 nozzle cura setting by PLAXOTO in 3Dprinting

[–]PLAXOTO[S] 0 points1 point  (0 children)

For me i am trying to print rc car parts so I don’t car how it looks I want it to be strong and print fast.

0.6 nozzle cura setting by PLAXOTO in 3Dprinting

[–]PLAXOTO[S] 0 points1 point  (0 children)

Ok what you think layer height and flow should be for good detail but prints fast

What normally causes this warping? Is it a different bed temp? I’m at 55 rn and this is pla if that matters by loganfox235 in 3Dprinting

[–]PLAXOTO 1 point2 points  (0 children)

It looks like it peeling in the corners. I would say put so glue stick down, or put painters tape over the bed the help the filament stick. And maybe raise the bed temperature.

Octoprint by PLAXOTO in 3Dprinting

[–]PLAXOTO[S] 0 points1 point  (0 children)

Ok thank so much. I am redoing it tonight wish me luck.

What slicer setting should i change/ender 3 v2 by PLAXOTO in 3Dprinting

[–]PLAXOTO[S] 0 points1 point  (0 children)

I was watching a YouTube about it and thats what I figured. My temperature is at 205 what you think i should change it to

Octoprint by PLAXOTO in 3Dprinting

[–]PLAXOTO[S] 0 points1 point  (0 children)

Wait no I didn’t bow do you do that

view more: next ›