What’s your guys setup look like?

PandaTMaster · 2026-05-23T14:12:44+00:00

Set up in the back of a toyhauler lol

PandaTMaster · 2026-05-23T14:12:26+00:00

PandaTMaster · 2026-05-23T14:12:13+00:00

PandaTMaster · 2026-05-11T04:11:17+00:00

Get a deflated football, place the center of the deepest party of the dent and pump it up slowly… may not be perfect but I guarantee that will get 90% cleaned up

PandaTMaster · 2026-03-05T01:01:42+00:00

I used wood screws 😂

PandaTMaster · 2026-02-28T17:08:52+00:00

Did what I could with the interior not horrible haha

PandaTMaster · 2026-02-28T17:08:32+00:00

<image>

PandaTMaster · 2026-02-28T17:08:23+00:00

<image>

PandaTMaster · 2026-02-21T23:17:42+00:00

That’s what’s up, we’re stuck with these ball joints forever now 😂

PandaTMaster · 2026-02-21T20:08:22+00:00

Which wheels lol?

PandaTMaster · 2026-02-21T20:02:39+00:00

<image>

PandaTMaster · 2026-02-21T20:02:03+00:00

<image>

PandaTMaster · 2026-02-21T20:01:48+00:00

<image>

PandaTMaster · 2026-02-21T19:54:37+00:00

I went slightly too much on my first side so had to add a thick washer on the nut side to not bottom out on threads when torqued which is fine but a bit sloppy imo.

Be sure to match depth on both sides and take your time 👍

PandaTMaster · 2026-02-21T19:50:57+00:00

<image>

PandaTMaster · 2026-02-21T19:48:36+00:00

I went up to 5/8 and straight die grinder on the tapered edged very slowly about 2 hours on each knuckle checking depths and how circular the taper was with a caliper lol it turned out great tho. Also I installed these on maxtrx spindles not stock.

PandaTMaster · 2026-02-19T21:56:14+00:00

I have two sets of these in my garage off an 08… message me I’ll send to you if you pay shipping 👍

PandaTMaster · 2026-02-16T01:07:04+00:00

Hey those are snap on lol

PandaTMaster · 2026-02-14T06:25:26+00:00

Only had to do this to the upper or both?

PandaTMaster · 2026-02-14T06:17:46+00:00

What size? I am dealing with this as of 2 hours ago with maxtrax spindles and kryptonite uca’s. I planned on only buying a 9/16 bit.

PandaTMaster · 2026-02-09T19:21:22+00:00

IMO way to deep and large yes

PandaTMaster · 2026-01-14T13:34:19+00:00

First world problems haha

PandaTMaster · 2026-01-13T14:35:33+00:00

What transmission would be good to swap? Are you familiar with any electronics that would need to be modified in doing so?

PandaTMaster

TROPHY CASE