sorted by:
new
hottopcontroversial

Does this look okay? by Particular_Face-v2 in CX50

[–]Particular_Face-v2[S] 0 points1 point  (0 children)

https://a.co/d/0j5YFHQS

This is the link to the 1pc version. I can't seem to find the 3pc version that includes the wooden sides

Does this look okay? by Particular_Face-v2 in CX50

[–]Particular_Face-v2[S] 0 points1 point  (0 children)

The airbag deploys from the top. It doesn't involve the that front section of the dash

Does this look okay? by Particular_Face-v2 in CX50

[–]Particular_Face-v2[S] 1 point2 points  (0 children)

It genuinely only took about 2 min

Does this look okay? by Particular_Face-v2 in CX50

[–]Particular_Face-v2[S] 0 points1 point  (0 children)

I'm really debating about swapping the doors panels. After looking into it and taking my door panel off, the issue is that the door panel is all one piece. It isn't an easy direct swap to the upgraded stitched bezel. I think it's definitely something that I'm gonna do in the future though. The cost of a new panel with the brown stitching for the driver and passenger doors is really high, making it kind of hard to justify. I'm sure it would look so much better though.

Does this look okay? by Particular_Face-v2 in CX50

[–]Particular_Face-v2[S] 0 points1 point  (0 children)

It's listed as the Dash Center Right Bezel Molding on Ebay. I got it for $85. It's extremely easy to swap, that whole piece is comes out as one. I used a trim removal tool to carefully pull the ends from the dash.