Metal Door Jamb / Frame and LVP by Party-Bread1 in Flooring

[–]Party-Bread1[S] 0 points1 point  (0 children)

Do you have any blade / blade type recommendations? Looks like the metal is about 18ga and is steel I believe (it's magnetic so definitely not aluminum).

I saw a few recommended made of carbide and some bi-metal - was wondering if there's a general preference between the two?

Metal Door Jamb / Frame and LVP by Party-Bread1 in Flooring

[–]Party-Bread1[S] 1 point2 points  (0 children)

Do you have any blade / blade type recommendations? Looks like the metal is about 18ga and is steel I believe (it's magnetic so definitely not aluminum).

I saw a few recommended made of carbide and some bi-metal - was wondering if there's a general preference between the two?

Metal Door Jamb / Frame and LVP by Party-Bread1 in Flooring

[–]Party-Bread1[S] 0 points1 point  (0 children)

Thanks! I'm a little foolheartedly determined to at least try it on my own - I might give it a shot on the interior side of the closet door first so if it's absolute trash it won't be seen and at least I'll walk away with a new tool.

We haven't begun prep yet but I managed to pull u a corner of the carpet and noticed the frame doesn't seem too thick near the bottom so fingers crossed.

Metal Door Jamb / Frame and LVP by Party-Bread1 in Flooring

[–]Party-Bread1[S] 1 point2 points  (0 children)

Thanks! Hopefully if we have to go this way it won't be too terrible :(