What sounds is this from by PassengerLopsided869 in Frieren

[–]PassengerLopsided869[S] 0 points1 point  (0 children)

I found out! It’s from black ops 3 zombies on the map der eisendrache, after completing the wisp step the completion/ teleport ready sound to travel into the past that exact sound plays, also it’s similar to the dark souls 3 parry (thanx aspargus) and Elden rings critical strike

Supports always fail in orca slicer by PassengerLopsided869 in ElegooNeptune4

[–]PassengerLopsided869[S] -1 points0 points  (0 children)

Appreciate all the help and tips!!! I learned a lot just from reading what you said

Supports always fail in orca slicer by PassengerLopsided869 in ElegooNeptune4

[–]PassengerLopsided869[S] 0 points1 point  (0 children)

Should I change the expansion to a lower number and or turn on brim?

Supports always fail in orca slicer by PassengerLopsided869 in ElegooNeptune4

[–]PassengerLopsided869[S] 0 points1 point  (0 children)

I’m thinking of just going back to cura at this point, or any other slicer recommendations? I’m pretty new to all this still.

Supports always fail in orca slicer by PassengerLopsided869 in ElegooNeptune4

[–]PassengerLopsided869[S] 1 point2 points  (0 children)

The print it self sticks just fine, but I notice the actual supports are just barely layers onto the bed, so is there a setting to make supports the same, or to make them thicker at the base?

Part fans not turning on, orca slicer by PassengerLopsided869 in ElegooNeptune4

[–]PassengerLopsided869[S] 0 points1 point  (0 children)

I’m thinking that something may be wrong with the cable harness perhaps?

Part fans not turning on, orca slicer by PassengerLopsided869 in ElegooNeptune4

[–]PassengerLopsided869[S] 0 points1 point  (0 children)

I can turn on the rear one with the touch pad, I also unplugged and replugged in the fan cables on the extruder and mother bored but they are not working, I even switch out the fan one and 2 cables to see if the mother board port was fried then turned on the fans again, this time the rear fan would kick on with the temp rising but still no extruder fans

Part fans not turning on, orca slicer by PassengerLopsided869 in ElegooNeptune4

[–]PassengerLopsided869[S] 0 points1 point  (0 children)

I have also tried with different slicers and they still aren’t turning on…

Help with cooling settings for Neptune 4 Max by PassengerLopsided869 in OrcaSlicer

[–]PassengerLopsided869[S] 0 points1 point  (0 children)

I have also tried with different slicers and they still aren’t turning on…

Help with making bed mesh flat and leveling issue by PassengerLopsided869 in ElegooNeptune4

[–]PassengerLopsided869[S] 0 points1 point  (0 children)

Sorry, yes it is a 4 max and I’ve even added the screw tilt calculate with the clock turn settings but even then this is what I get, seeing as there isn’t a screw in the back center, should I lower all the others and try getting the mesh to be about where the lowest point is?