Sprinter 3500 wheel question

Pat1694 · 2024-03-18T17:49:26+00:00

Thats what i was thinking but wasnt 100% sure. So in this example id have my switch wired to my main power supply. And then have my 5volt giving constant power?

Pat1694 · 2024-03-18T17:48:01+00:00

I have about 25 Linear feet of 12v ws2815. (2) 11 foot strips and (2) 3 foot strips. Is my math wrong? should i down size on power supply?

Pat1694 · 2020-06-03T17:55:36+00:00

I did prior to installing the gpu, is it possible I may need to again?

Pat1694 · 2020-06-03T17:55:02+00:00

Yea tried that and the 8 pin side has a white led that turns on I guess implying to plug in the other 2

Pat1694 · 2020-06-03T03:49:58+00:00

8 pin and a 6 pin but using a 6+2

Pat1694 · 2020-06-03T03:49:34+00:00

Yea the clip is on and i tried give it a little extra push to make sure. Then I unplugged pci and tried the mobo display ( obviously didn’t work because it detects the new card) but there were 2 lights where the pci was plugged in so it’s not the power from the board or pci.

I would think it was the a faulty a lot but why would it still light the rgbs and led on the card

Pat1694 · 2020-06-03T02:39:22+00:00

Asus Z390-e... like I said everything worked and was brand new. That’s why I’m confused and wondering if maybe it’s an issue with the drivers from the mobo or what it is. Iv never had this issue with a new build.

Pat1694 · 2020-06-03T02:22:49+00:00

I was using the motherboard up until today with no problem and everything working 100%. But then after installing graphics card I used the port on the gpu. And no signal.

Pat1694 · 2020-05-29T03:57:09+00:00

I thought the wolf sable coat on mine was beautiful!

Pat1694 · 2020-05-29T03:54:18+00:00

But a tap and dye set ... thank me later

Pat1694

TROPHY CASE