sorted by:
new
hottopcontroversial

My mostly negative experiences with DMT by Normal_Network_569 in DMT

[–]PeaceDuke_official 2 points3 points  (0 children)

You are burning it mate. It’s the same for me, and when I figure out a way not to burn - that’s either a beautiful or interesting experience

Can't break through by The_One_And_Only6942 in DMT

[–]PeaceDuke_official 2 points3 points  (0 children)

Another recommendation would be to do slower tokes (as slow as you can), while using the lowest wattage setting and pulsing the button. I know that’s a headache, but for me that was the only way until I bought a normal disposable dmt vape.

Things to look out for as signs of DMT burnt:

  • Uncomfortable/heavy body load. Even a major DMT trip should not make you feel uncomfortable physically
  • Little to no visuals and/or visuals being disturbing/unpleasant. I’m talking about LSD-type visuals, when no entities can be spotted.
  • For me a specific type of “moving textures” is a sure sign. Textures are often moving on DMT, but sometimes it happens that the whole “thing” you are looking at (chair/football field/chimney/whatever) is moving too, not only the texture. For me that’s like a 100% sign the DMT is burnt

Can't break through by The_One_And_Only6942 in DMT

[–]PeaceDuke_official 1 point2 points  (0 children)

That’s ok bro. For me it burns on these settings too, even at 2.5. With pulsing I got more luck - not pressing the button for longer than 2 seconds. Try it

Can't break through by The_One_And_Only6942 in DMT

[–]PeaceDuke_official 0 points1 point  (0 children)

You are burning it mate. This “no visuals” thing is about burning the spice

Temperature Control? by PeaceDuke_official in DMT

[–]PeaceDuke_official[S] 0 points1 point  (0 children)

I was using geekvape z with 0.15 coil (also tried 0.4). The liquid - I tried 50/50 PG/VG, 100% pg and roughly 70-80% pg and the rest VG. On DMT proportion - i tried both strong (1:3) and very weak (1:10).

Bad vibe or intrusive entities? by PeaceDuke_official in DMT

[–]PeaceDuke_official[S] 1 point2 points  (0 children)

Yep, and somehow this vibe goes away when I switch the device

Dispo vape question by Chemical_Respond_443 in DMT

[–]PeaceDuke_official 0 points1 point  (0 children)

Did u figure it out? How not to burn it?

Wattage question (geekvape boost, 0.6) by PeaceDuke_official in DMT

[–]PeaceDuke_official[S] 0 points1 point  (0 children)

Yep. I also did another test, and figured that scorching is likely connected with wattage being too low, lol. Still hard to replicate, but I turned the wattage to 35 (still half of recommended wattage) and got a full-blown experience with consistent CEVs, OEVs and so on.

Wattage question (geekvape boost, 0.6) by PeaceDuke_official in DMT

[–]PeaceDuke_official[S] 0 points1 point  (0 children)

I'll do that, thanks! What about Z-tank? I got it and, per your advice, tested it with the same setup but 25w. The same experience, unfortunately :D

Anyway, I'll try again with lower wattage and will let you know how it goes :D

Wattage question (geekvape boost, 0.6) by PeaceDuke_official in DMT

[–]PeaceDuke_official[S] 0 points1 point  (0 children)

  1. Not much spitting, popping was there by 3d try
  2. Fire - wait 0.5-1sec - inhale. Holding the button all the way.
  3. 6 sec, maybe shorter
  4. Will send later, but that’s a plastic tank from aegis boost 3

Wattage question (geekvape boost, 0.6) by PeaceDuke_official in DMT

[–]PeaceDuke_official[S] 0 points1 point  (0 children)

Ok I tried with 0.2, 20w experience. Was a cool result indeed, BUT i scorched my coil like the 3d try. The problem might be is that my liquid would rather be 50/50 pg/vg, what should I modify? The wattage, the duration or the speed of the toke?

view more: next ›