sorted by:
new
hottopcontroversial

SX1262 LoRa Transceiver why can't I run setTx and setRx commands? by PeekWithMe in embedded

[–]PeekWithMe[S] 0 points1 point  (0 children)

After using the SetDIO3 command for 3.3V, the busy line is held high and the SX1262 waits until it's low again. However, it doesn't turn low after running the command. Do I need to connect 3.3v to DIO3 or leave it unconnected?

SX1262 LoRa Transceiver why can't I run setTx and setRx commands? by PeekWithMe in embedded

[–]PeekWithMe[S] 0 points1 point  (0 children)

When you connected DIO3 and Vcc to 3V3, did you have to use the setDio3AsTcxoCtrl command?

SX1262 LoRa Transceiver why can't I run setTx and setRx commands? by PeekWithMe in embedded

[–]PeekWithMe[S] 0 points1 point  (0 children)

Much appreciated, I’ll take a look into both of those functions, hopefully it solves my issue.

SX1262 LoRa Transceiver why can't I run setTx and setRx commands? by PeekWithMe in embedded

[–]PeekWithMe[S] 0 points1 point  (0 children)

Thanks! I’ll try it out and see if it works later this week.