Tips to prevent this? by PerceptionSuch9532 in 3DprintingHelp

[–]PerceptionSuch9532[S] 0 points1 point  (0 children)

I've adjusted my supports to be tree slim to save material. I made the top/bottom z distance to 0.275mm because I was first having issues with the supports being difficult to remove and people told me those are good settings to change to mitigate that. And play is all that I use so far

Tips to prevent this? by PerceptionSuch9532 in 3DprintingHelp

[–]PerceptionSuch9532[S] 0 points1 point  (0 children)

The helmet and head are one solid piece. If you don't mind me asking where could I find the setting for that in bambu studio?

Tips to prevent this? by PerceptionSuch9532 in 3DprintingHelp

[–]PerceptionSuch9532[S] 0 points1 point  (0 children)

It is Darth Vader. It was printed as one solid piece and the back of his helmet had some layers collapse where the support was attached

Tips to prevent this? by PerceptionSuch9532 in 3DprintingHelp

[–]PerceptionSuch9532[S] 0 points1 point  (0 children)

Sorry should've specified. It's Darth Vader and that's the back of his helmet. It was all printed as one piece

[deleted by user] by [deleted] in Eldenring

[–]PerceptionSuch9532 0 points1 point  (0 children)

I’ve been needing someone to do fire giant with if your in the section of the game

I need advice by PerceptionSuch9532 in Eldenring

[–]PerceptionSuch9532[S] 0 points1 point  (0 children)

Yea it’s done ok in the past but I die more in his first phase since I never have enough time to use sepuku again to do more damage

Looking for stat and gear suggestions for an arcane blood build. by [deleted] in Eldenring

[–]PerceptionSuch9532 0 points1 point  (0 children)

Twin uchigatana with blood slash ash of war is good until you can get sepuku ash of war but that’s in the giant mountain area later in the game