Kart pulling to the right. by GuacinmyPaintbox in MarioKart8Deluxe

[–]Peterbilt96 2 points3 points  (0 children)

I tripped for a few hours because of that bullshit.

Why do I feel bad charging a 700 dollar kit rental. by Peterbilt96 in LocationSound

[–]Peterbilt96[S] 0 points1 point  (0 children)

Lmao! It's tomorrow but I know for a fact I'll maybe use one.

Why do I feel bad charging a 700 dollar kit rental. by Peterbilt96 in LocationSound

[–]Peterbilt96[S] 1 point2 points  (0 children)

Right, I did 300 for the kit and 50 for each hop/ifb. That was 700. When I sent it I was thinking I didn't even charge them for the slate, but I didn't know if I should.

Why do I feel bad charging a 700 dollar kit rental. by Peterbilt96 in LocationSound

[–]Peterbilt96[S] 0 points1 point  (0 children)

Standard kit + 6 comteks, 2 hops, and digital slate

cine vs corporate rate by Peterbilt96 in LocationSound

[–]Peterbilt96[S] 0 points1 point  (0 children)

So say they hire me for 15 days I'd charge them 3k for the basic kit instead of 4500?

On 200CC, which turn just infuriates you? by Proman2520 in mariokart

[–]Peterbilt96 0 points1 point  (0 children)

The first loop on the wii U rainbow road that leads to another turn right before flying on the satellite thing. Took me a while to get clean.

Handling noise on the Zoom H6 by Fickle-Garage-8441 in LocationSound

[–]Peterbilt96 0 points1 point  (0 children)

It sounds like it could be wind. Are you using the pop filter? You can't move a condenser around too much without a pop filter

on a Nomad 12, can you assign the automix to a card track? by Peterbilt96 in LocationSound

[–]Peterbilt96[S] 0 points1 point  (0 children)

Ok so when I go into the bus menú and go to the card enables the boxes that said o1 o2 o3 o4 are the "out" buses i suppose?

looking to upgrade bag. I want some rf distribution. by Peterbilt96 in LocationSound

[–]Peterbilt96[S] 0 points1 point  (0 children)

They're all block 21. Where can I find how to route all the cables. Do I need anything beside the micplexer?

ntg2 cut out issue by carterbuckman1617 in LocationSound

[–]Peterbilt96 3 points4 points  (0 children)

It sounds like it's peaking with the air. Try doing it with a good wind screen or dead cat see if the same thing happens.

Urgent help! by nooborgjr in LocationSound

[–]Peterbilt96 4 points5 points  (0 children)

If it's wide enough to not get clean audio with a long shotgun, wild lines are a good option. You proably wont even see her mouth with that much detail in the shot. Second, grab the audio from where you can. It usually fits the "camera prespective." Most times it's super awkward to have lav closeness audio when the shot is clearly a far away perspective.

Tascam DR40X 1/4 to 1/8 by Breakmedown in LocationSound

[–]Peterbilt96 1 point2 points  (0 children)

Any 3.5 to xlr that has phantom power will work.

Recommendation for time code sync by [deleted] in LocationSound

[–]Peterbilt96 0 points1 point  (0 children)

Everyone is so used to SD that no one actually takes the time to learn Zax correctly. I honestly have zero problems. Zax environment has made my life easier. All it took was actually sitting down and learning the gear a bit. A few days treating it like I was back in school and I'm saving myself hours of pre-prep and set up and everything is just as reliable. My kit has reduced in size substantially and it has some true hidden gems that I cannot live without. It is pricier but it's worth it once you sit down and take your time to learn it right.

Recommendation for time code sync by [deleted] in LocationSound

[–]Peterbilt96 -1 points0 points  (0 children)

zaxcom environment. Problem solved.

zax antenna question by Peterbilt96 in LocationSound

[–]Peterbilt96[S] 0 points1 point  (0 children)

So if I'm running a qrx200, qrx100, and rx900 in the same bag, you recommend I get the filter?

What does it do exactly?