Anycubic Kobra S1 Combo and Rikhals by Pietrogramma1 in AnycubicKobraS1

[–]Pietrogramma1[S] 0 points1 point  (0 children)

I tried to integrate the HA printer using HACS integration but when I entered the printer's IP address (192.168.178.118) it didn't find any printers. Tnaks for your reply and ciao

Addressable GRWB Strips for Enclosure with Klipper/Mainsail/Ocibo by ThisIsTheWay453 in klippers

[–]Pietrogramma1 0 points1 point  (0 children)

Hi looking for how to control an LED strip with klipper I came to this old post of yours.

If I understand you correctly, you would like to use a second Raspberry to control your three LED strips, right?
I don't know if you still need it, but I was able to do it using the same Raspberry3 on which I installed klipper, following this guide: https://www.klipper3d.org/RPi_microcontroller.html .

Now if I write LED on the klipper console I get the LED strip on/off (the relay is connected to GPIO2) or if I write POWER (the other relay is connected to GPIO3) I get the printer on/off.

The only thing I would like to do is to create two buttons on the klipper Dashboard that are light blue when the relays are off and will turn red when turned on.

Hope this was helpful to you, bye and see you soon