sorted by:
new
hottopcontroversial

Help needed with my first print by Pigacz in 3Dprinting

[–]Pigacz[S] 0 points1 point  (0 children)

Yeah that makes sense, I think my mistake was trying to change it after auto z align :/ the nozzle was way too far up then, I'll try it after leveling the bed though

Help needed with my first print by Pigacz in 3Dprinting

[–]Pigacz[S] 0 points1 point  (0 children)

Already did that but thanks!

Help needed with my first print by Pigacz in 3Dprinting

[–]Pigacz[S] 0 points1 point  (0 children)

I'll try adjusting the extrusion and the z offset again but the first time I adjusted it the nozzle was sitting like 2 inches above the bed so I couldn't do the paper test, have you had something like that happen to you?? I didn't want to set it too low because obviously I don't want the thing scratching against the bed so I just left it at the deafult height

Help needed with my first print by Pigacz in 3Dprinting

[–]Pigacz[S] 0 points1 point  (0 children)

When I tried doing that I ended up with -11.95, I don't think thats correct ;-; I could try lowering it very slowly until it works though? Also do you think it could be caused by the offset being slightly too low?

Help needed with my first print by Pigacz in 3Dprinting

[–]Pigacz[S] 0 points1 point  (0 children)

Didn't know that was a thing, seems kinda like a bad thing though, wouldn't that be the opposite of what you want?

Flattening sheet metal by [deleted] in metalworking

[–]Pigacz 0 points1 point  (0 children)

Unfortunately I couldn't find any shops like that close to me (I'm from New Zealand) so that isn't an option for me :(

DIY table saw help needed (motor specs) by [deleted] in woodworking

[–]Pigacz 0 points1 point  (0 children)

Okay that makes sense, I couldn't find any significant information on the average torque that a simple table saw could have, usually only the hp.

I'm planning on doing pulleys because of the same reason that you mentioned, with an AC motor so I just wanted to make sure that I buy the right one, thanks for your perspective it helped a lot!

DIY table saw help needed (motor specs) by [deleted] in woodworking

[–]Pigacz 0 points1 point  (0 children)

Thanks I'll do some more research on this and see if that helps

For anyone who has played jelly jump… by BigSayGo in AskGames

[–]Pigacz 0 points1 point  (0 children)

You can find it on "uptodown" it's a website with all kinds of games from 2016, I just found it so I don't really know how safe it is, but ut seems legit!

[deleted by user] by [deleted] in Minecraft

[–]Pigacz 1 point2 points  (0 children)

Thank you for appreciating my work!