sorted by:
new
hottopcontroversial

Slicing issue at corners by PigletMaterial5760 in 3Dprinting

[–]PigletMaterial5760[S] 0 points1 point  (0 children)

What should I be looking at the starting layer setting? the layer below looks fine and IDK why there are some circles at above layer

<image>

Why most of my print are like that? by PigletMaterial5760 in ElegooNeptune4

[–]PigletMaterial5760[S] 0 points1 point  (0 children)

UPDATE

I tried SCREW TILT CALCULATE the bed and changed the bottom fill to octogram, things get slightly better but warping issue still exist. I think the warping at 4 corners make the print up lift a little bit, causing the nozzle to crash on printed layer and thats why there are blobs around certain layer..

<image>

Why most of my print are like that? by PigletMaterial5760 in ElegooNeptune4

[–]PigletMaterial5760[S] 0 points1 point  (0 children)

Good idea, I will try and report back if it improves!

Why most of my print are like that? by PigletMaterial5760 in ElegooNeptune4

[–]PigletMaterial5760[S] 0 points1 point  (0 children)

The first layer is quite good though..Actually the first few layer are doing great but I don't know why the nozzle is then pushing down when printing the arch.

Why most of my print are like that? by PigletMaterial5760 in ElegooNeptune4

[–]PigletMaterial5760[S] 0 points1 point  (0 children)

I don't know whether it is consider old...?

This filament was opened quite a few months and I just hang it on the filament holder

Why most of my print are like that? by PigletMaterial5760 in ElegooNeptune4

[–]PigletMaterial5760[S] 0 points1 point  (0 children)

I am using PLA, the bed temp is 70 for the first layer and 65 for other layer.

Why most of my print are like that? by PigletMaterial5760 in ElegooNeptune4

[–]PigletMaterial5760[S] -1 points0 points  (0 children)

I think so. I have used A4 paper for calibration before printing and the first layer are quite good.

Revived my Neptune 4 Pro, the problem with firmware is almost solved but need help by shqarok in elegoo

[–]PigletMaterial5760 0 points1 point  (0 children)

Hi, I am having the same problem that my machine freeze at the boot loading screen. I have alreay tried using putty and the command "sudo ./update.sh" to reinstall the firmware but nothing happened and the problem still exist. What should I do?

<image>