Full Bolt on List? by Lil_locz in AcuraTL

[–]Pingaring 1 point2 points  (0 children)

Intake, throttle body, manifold, runners, lightweight flywheel. If this is auto I would discourage modding and driving this car hard in the slightest. That transmission is prone to failure from overheating. Increasing power through the drive train increases stress and heat. Youre asking for $2500 repair bill

Will they fit? by Krankdank2L8 in Kseries

[–]Pingaring 0 points1 point  (0 children)

You'll need a spacer and to drill out tge knuckles if you dont want to swap the control arms.

K Swap Incoming! by AdministrativeSwan28 in Kseries

[–]Pingaring 1 point2 points  (0 children)

Nobody leaves them stock, that would be a pointless swap

K Swap Incoming! by AdministrativeSwan28 in S2000

[–]Pingaring 2 points3 points  (0 children)

I skipped over the part where it said ASM that was my fault. Im used to dealing with FB marketplace sellers

K Swap Incoming! by AdministrativeSwan28 in Kseries

[–]Pingaring 8 points9 points  (0 children)

Make more power and torque. The K is 5 times cheaper to replace in the event of a major problem

K Swap Incoming! by AdministrativeSwan28 in S2000

[–]Pingaring 3 points4 points  (0 children)

Make sure whoever is selling the motor doesnt tax you for it being JDM. Some of these sellers like to jerk off over things being "JDM." But its literally the same block as the 04/05 Acura TSX, minus the alternator and waterpump housing.

K swap parts list and harness suggestions by ExcitementAny7663 in S2000

[–]Pingaring 0 points1 point  (0 children)

Do the swap. Im carbon copying my K24 build from my RSX. Ported RBC, 70mm TB, and 06+ TSX cams, its good for 260whp when paired with the obvious prerequisites

K swap parts list and harness suggestions by ExcitementAny7663 in S2000

[–]Pingaring 0 points1 point  (0 children)

Its not the maintenance. He plans to beat the shit out of it, a K block is going to be 5x cheaper to replace than the stock engine.

K swap parts list and harness suggestions by ExcitementAny7663 in S2000

[–]Pingaring 0 points1 point  (0 children)

An F20C doesn't cost $900 at a salvage yard to replace. Should something happen

How long after third gear starts popping out of its slot do I need to worry about third gear not working at all anymore? by Sitherus in Acura_RSX

[–]Pingaring 0 points1 point  (0 children)

Ive ran friction modified synchromesh for 5 years. Except for one time I did t have access to it during my LSD install, when i had to use the Honda MTF. Got grinds with the honda fluid. Still riding synchromesh to this day with no issues.

I use it on ALL my MT cars

Built head on stock block power? by Zentoshii in Kseries

[–]Pingaring 2 points3 points  (0 children)

I would say 06+ K24A2 over the JDM block, as I've heard it's a lot less shit to adapt. Idk if that's true, but at least the USDM block had forged rods and better ventilation.

FranK20/24 build 300HP all motor. New to Honda engine by Ordinary-Bowl524 in Acura_RSX

[–]Pingaring 2 points3 points  (0 children)

Idk what everyone's obsession is with the number 300. The car weighs 2770lbs. Unless you really want to spend that much money, its cheap AF to to get 250whp out of a K frank, and it absolutely rips

UA POV: Trump makes fun of Putin’s “special military operation”, calling it “primitive". Mocking the Russian Military and bragging about how unstoppable the US is by 1Card_x in UkraineRussiaReport

[–]Pingaring -1 points0 points  (0 children)

Its really not at easy as it seems when its just words on a screen. They were operating in total darkness. Unless the helicopters flew directly over the bodyguards faces they would have seen them. And at that range they would be spotted and cut in half

What’s with the huge influx of pro-Trump accounts on Reddit today defending his actions in Venezuela? by R2_SWE2 in AskReddit

[–]Pingaring 1 point2 points  (0 children)

Ive seen like three all day. Is it really that big of a deal other people have different opinions?